Toshiba Strata Dk24, Dk56, Dk96 Instruction Manual

STANDARD 
TELEPHONE 
U S E R G U I D E 
STRATA DK 
DIGITAL KEY 
TELEPHONE SYSTEMS 
STRATA DK24 
DK56 AND DK96 
RELEASE 1, 2, & 3 
TABLE OF CONTENTS 
General Information .............................................................. 1 
Outside Calls ........................................................................ 2 
Intercom Calls ....................................................................... 3 
Automatic Callback-Intercom ................................................ 4 
Call...

GENERAL INFORMATION 
Using a standard telephone with your STRATA DK digital tele- 
phone system provides easy access to the wide range of 
features listed in this guide. 
Intercom dial tone must be heard before dialing; if you have just 
lifted the handset, you will hear intercom dial tone. During a 
conversation, intercom dial tone is obtained by “flashing” the 
hookswitch (plunger) located in the handset cradle. To flash, 
depress the hookswitch momentarily (for about a l/2 second), 
and you will hear...

OUTSIDE CALLS INTERCOM CALLS 
TO MAKE AN OUTSIDE CALL 
1) Lift the handset 
l You will hear intercom dial tone. 
2) Dial the CO line access code.* 
3) Listen for CO (outside line) dial tone. 
4) Dial the desired telephone number. 
5) Hang up when the call is completed. 
*Dial 1 to access the general group or to use /east cost 
dial a CO line number d 11 * 0 11); or dial 
to access line groups 1 * 8, respectively. 
TO RECEIVE AN INCOMING CALL 
1) You will hear ringing (two short rings every four seconds’...

AUTOMATIC CALLBACK-Intercom 
After reaching a busy (fast busy-two tones per second) or DND 
station (very fast busy-four tones per second) on an intercom 
call, you may use Automatic Callback. 
TO USE AUTOMATIC CALLBACK 
1) Dial a to set Automatic Callback. 
l Busy tone stops. 
l You will hear dial tone for two seconds and then busy 
tone again. 
2) You may go on-hook or make other calls while waiting for 
the called station to become available. 
3) When the called station becomes idle: 
l Your telephone...

CALL HOLDING CALL TRANSFER WITH CAMP-ON 
TO HOLD A CALL 
1) While connected to an outside call, flash the hookswitch. 
l You will hear intercom dial tone. 
2) Dial 10 and hang up (at least 2 seconds). 
l You may now originate or receive other calls. 
TO RETURN TO CALL ON HOLD* 
1) Lift the handset. 
l You will hear intercom dial tone. 
2) Dial B 1. 
l You will be reconnected with the call. 
NOTES: 
1. If you do not return to the call within a designated time 
period, your telephone will ring to recall...

CONFERENCE CALLS 
CONFERENCE CALLS (continued) 
8 TO CONFERENCE UP TO THREE STATIONS ON ONE CO 
LINE 
While connected to an established CO line call (incoming or 
outgoing): 
1) Flash the hookswitch. 
l You will hear intercom dial tone. 
l The existing call will be on hold. 
2) Dial the number of the desired station. 
3) Flash the hookswitch after the party answers.* 
l All parties will be conferenced. 
4) Repeat to add another station. (Two stations, plus yours, 
and one CO line is maximum.) 
5) Hang up...

DOOR PHONE ACCOUNT CODE CALLS 
TO CALL/MONITOR A DOOR PHONE 
1) Lift the handset. 
l You will hear intercom dial tone. 
2) Dial the intercom number for the desired door location. 
151 Location 
152 Location 
153 Location 
154 Location 
155 Location 
156 Location 
157 Location 
158 Location 
159 Location 
161 Location 
162 Location 
163 Location 
3) Hang up when the call is completed or when you no longer 
wish to monitor the door phone. 
NOTE: 
Door phones will not ring standard telephones. 
FLASH CO...

ACCOUNT CODE CALLS (continued) OVERRIDE (continued) 
4A) Hang up or resume talking. 
. . . or. . . 
4B) If voluntary account codes are verified (Release 3): 
l If a valid code is dialed, you will hear one confirmation 
burst tone. Hang up or resume talking. 
l If an invalid code is dialed, you will hear two confirma- 
tion burst tones. Repeat steps 1 N 3 to enter another 
code, or hang up, or resume talking. 
MESSAGE SENDING 
TO SET MESSAGE WAITING TO AN ELECTRONIC OR 
DIGITAL TELEPHONE 
1) Lift the...

REPEAT LAST NUMBER DIALED 
VOICE/TONE SIGNALING 
PROGRAMMABLE OPTION 
TO USE REPEAT LAST NUMBER DIALED 
1) Lift the handset. 
l You will hear intercom dial tone. 
2) Dial 1. 
l You will hear dial tone and the number will be dialed. 
SPEED DIAL 
TO STORE A STATION SPEED DIAL NUMBER 
1) Lift the handset. 
l You will hear intercom dial tone. 
2) Dial 11. 
l You will hear a short tone. 
3) Dial 1 p. 
4) Dial a 2-digit dialing code (10 w 49). 
5) Dial the CO line access code to be stored (701 * 736,81 w 
89,...

CO LINE QUEUING (continued) CALL PARK (continued) 
NOTES: 
1. You may cancel the request at anytime prior to the 
actual callback by lifting the handset and dialing 0 1. 
2. If the call wasp/aced using LCR (dials), the telephone 
number is automatically redialed in step 4. 
3. If, after answering a callback, you hear a busy tone, it 
means the trunk has already been accessed or re- 
ceivedan incoming call. Your request is not cancelled. 
You will be called again the next time a trunk becomes 
idle. 
CALL...