Toshiba Strata Dk14, Dk40i, Dk424 Programming Manual

System & Station
Programs 81~89 – Ground/Loop Start/CO Line Station Ringing
Strata DK Programming 5/993-175
System & Station
Programs 81~89 – Ground/Loop Start/CO Line Station 
Ringing
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default:All LEDs ON for Port 000 (81), Port 001 (87), all other LEDs OFF




  6SNU  +ROG  6SNU +ROG 6SNU+ROG 6SNU+ROG
ProcessorStation Port 
RangeDH PortCO LineProcessorStation Port 
RangeDH PortCO Line
DK14 000~009 900~909 001~004...

System & Station
Programs 81~89 – Ground/Loop Start/CO Line Station Ringing
3-176Strata DK Programming 5/99
Program 81~89 Overview
Programs 81~89 assign telephones or a Distributed Hunt group to each CO line that will ring. 
Use Programs *81, *84 and *87 to assign which [PDN] and/or [PhDN] buttons flash when a call 
comes in on various CO lines. 
©If the telephone has a specific CO /LQH button or 3RROHG/LQH*US button, do not use 
Programs *81, *84 or *87 to assign [DN] LEDs to flash. This will cause...

System & Station
Programs 81~89 – Ground/Loop Start/CO Line Station Ringing
Strata DK Programming 5/993-177
System & Station
Day, Day2, Night refer to the 1LJKW7UDQVIHU button’s three modes. 
Attendant Console (DK424 only)
Programs 81~89 are used to ring individual attendant consoles and/or to enable attendant console 
incoming CO line call load sharing. (See “Auto Attendant Delay Ring” and “PC and Conventional 
Attendant Console Programming Overview” in Chapter 5 – Station Apparatus of the Strata DK...

System & Station
Programs 81~89 – Ground/Loop Start/CO Line Station Ringing
3-178Strata DK Programming 5/99
©Station assigned in Program 82 and the [DN] assigned in Program *81 – ring after a 12-
second delay for 12 seconds and then stop ringing. Assign the appropriate [DN] or 
/LQH 
or 
3RROHG/LQH*US buttons to these ports using Program 39.
4. Assign any station to ring the AA CO lines in Program 83 (86 – Day 2, 89 – Night). This 
assignment is only a flag that notifies the software to delay ring...

System & Station
Programs *81, *84, and *87 – Ground/Loop Start/CO Line to [DN] LED Flash Assignments
Strata DK Programming 5/993-179
System & Station
Programs *81, *84, and *87 – Ground/Loop Start/CO 
Line to [DN] LED Flash Assignments
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default:CO 018~200 flashes Port 000 (*81) and Port 001 (*87)
Important!Blank out initialized default data if CO line should not ring and flash [PDN] 
assigned to port 000 and port 001. If this...

System & Station
Programs *81, *84, and *87 – Ground/Loop Start/CO Line to [DN] LED Flash Assignments
3-180Strata DK Programming 5/99
Programs *81, *84 and *87 Overview
Ground/loop start CO lines can be assigned to ring and flash specific Directory Number buttons, 
including [PDNs], [SDNs] or [PhDNs]. These programs assign which [DN] will flash when a 
ground/loop start CO line rings a direct incoming call to the DK system.
Programs 81~89 must be used in conjunction with Programs *81, *84, and *87 to...

System & Station
Programs *81, *84, and *87 – Ground/Loop Start/CO Line to [DN] LED Flash Assignments
Strata DK Programming 5/993-181
System & Station
Figure 3-2 Strata DK CO Line Button/Directory Number [DN] Button Ringing Control Logic Diagram
Telephone
Receives Beep
and Camp-On Tone Telephone Receives
Ring ToneTelephone Does Not
Ring Telephone May
Receive Camp-On
Tone
3
Telephone Receives
No Ring2
Program 39
CO Line
Button
I-Use or Red Program 
*81
[DN] 1 HZ
Program 81
Program
 *81
EKT/DKT
[DN]
Idle...

System & Station
Programs *81, *84, and *87 – Ground/Loop Start/CO Line to [DN] LED Flash Assignments
3-182Strata DK Programming 5/99
Program *81 CO Line to Station [DN] LED flashing Control Logic also applies to Programs *84 
and *87.
Program 81 CO Line to Station Ringing Control Logic also applies to Programs 82~89.
Important!System Record Sheets for Programs 90, 91, and 92 appear in the beginning of this 
section because they must be executed prior to running any other programs.
Telephone CO Line...

System & Station
Program 93 – CO Line Identification
Strata DK Programming 5/993-183
System & Station
Program 93 – CO Line Identification
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default:Blank
 
Program 93 Overview
Assigns alphanumeric names (such as “WATS BAND 5”, “FX TO NY,” “MR JONES,” etc.) to 
lines. The names can be up to 16 characters each, and display when the line is being used by an 
LCD station. When programmed to display, Caller ID, DNIS, ANI, and ACD call...

System & Station
Program 93 – CO Line Identification
3-184Strata DK Programming 5/99
äTo enter CO line identification
1. Enter Program 93 and select the desired CO line.
2. Using the guide below enter the CO line identification information.
Numeric Mode
~ are treated as numerals.
Dial pad starts in numeric mode. Press 
 to switch to alpha mode.
Alpha Mode
Moves cursor to left
Scrolls alpha and
special characters
Alpha Entry (Example): Special Character Entry:
Alpha 
CharacterEntry
Sequence
Special...