Toshiba Strata Dk14, Dk40i, Dk424 Programming Manual

System & Station
Program 72 – DNIS Number Network Table Assignments
Strata DK Programming 5/993-155
System & Station
Program 72 Overview
This program defines the external Network routing numbers that can be assigned DNIS/Tie/DID 
extension numbers in the Day, Day2, or Night ringing mode. This assignment will cause incoming 
DNIS/Tie/DID calls to route (forward) back out over a public, or private, telephone network to a 
pre-assigned telephone number.
To assign a Tie/DID line to Program 72 assignments:...

System & Station
Program 74 – System NT Button Lock Password
3-156Strata DK Programming 5/99
Program 74 – System NT Button Lock Password
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default:Port 000 for all tenants
Program 74 Overview
This program assigns the password for each 1LJKW7UDQVIHU or 1LJKW7UDQVIHUa button. To 
lock the system ringing mode requires a password and two buttons: 
1LJKW7UDQVIHU and 1LJKW
7UDQVIHU/RFN
.
©1LJKW7UDQVIHU switches the station to Night...

System & Station
Program 76-1(X-Y) – DK14, DK40i, All RCTUs
Strata DK Programming 5/993-157
System & Station
Program 76-1(X-Y) – DK14, DK40i, All RCTUs
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default: Port 1 (Type 1), Ports 2~4 (Type 0)
Program 76-1 Overview
This program assigns each installed WSIU (DK14 only), TSIU (DK40i only) or RSIU/RSIS 
(DK424 only) port to a function. 
For Program 76-1(X-Y):
X identifies the WSIU, TSIU port number 1~2 or RSIU/RSIS/RMDS port number...

System & Station
Program 76-2 (X-Z) – WSIU, TSIU and RSIU / RSIS / RMDS Transmission Rates
3-158Strata DK Programming 5/99
Program 76-2 (X-Z) – WSIU, TSIU and RSIU / RSIS / 
RMDS Transmission Rates
Processor Type:DK14, DK40i, All RCTUs
Program Type:System
Initialized Default: All ports 2400 bps
Program 76-2 Overview
Assigns each installed WSIU (DK14 only), TSIU (DK40i only) or RSIU port to operate at a 
specified transmission rate. Where X identifies the WSIU, TSIU port number 1~2 or RSIU/RSIS/
RMDS port...

System & Station
Program 77-1 – Peripheral Options (Door Phones)
Strata DK Programming 5/993-159
System & Station
Program 77-1 – Peripheral Options (Door Phones)
RSIU / RSIS / RMDS, PIOU/PIOUS / IMDU, PEPU
Processor Type: DK14, DK40i, All RCTUs
Program Type:System
Initialized Default:All LEDs are OFF




  6SNU   +ROG  6SNU +ROG 6SNU+ROG 6SNU+ROG
LED/
ButtonXLED ONLED OFF
20Door Lock Time/6 seconds Door Lock Time/3 seconds
19Port 028/DDCB 4 or HDCB 4 (DK424) Port 028/Telephone...

System & Station
Program 77-1 – Peripheral Options (Door Phones)
3-160Strata DK Programming 5/99
Program 77-1 Overview
This program performs the following functions:
©Programs door lock relays
©Assigns door phones/lock control units
©Enables RMDS/IMDU built-in maintenance modems
©Sets RMDS communications standard type
©Enables DKAdmin Communications Protocol
©Enables/disables door phone ring tone to external paging when system is in Night mode
©Assigns a relay to operate with door lock function or...

System & Station
Program 77-1 – Peripheral Options (Door Phones)
Strata DK Programming 5/993-161
System & Station
LED 14: RMDS or IMDU Modem
DK424: This program enables the DK424 built-in maintenance modem function: RMDS or 
IMDU. If LED 14 is off, the RSIU Port (1~4) which is set for TTY operation (Code 1 in 
Program 76-1) will operate as a local RS-232 maintenance port. If RSIU is not configured as 
TTY, then the PIOU/PIOUS/RSSU that has code 41 set in Program 03, will operate as a local 
TTY...

System & Station
Program 77-1 – Peripheral Options (Door Phones)
3-162Strata DK Programming 5/99
LED 06: NT Relay
A relay located on the PIOU, PIOUS, PEPU, DK14 KSU or DK40i KSU can be assigned to 
operate in one of two Night Transfer modes (see next item, MOH/NT Relay).
©DK14: Activate the NT Relay in the DK14 KSU before
 setting the specific Night Transfer 
mode with LED 06.
©DK40i: Activate the NT Relay on the PIOU or PIOUS with LED05, or activate the NT Relay 
on the DK40i KSU with LED 01 before...

System & Station
Program 77-2 – Door Phone Busy Signal/Door Lock Assignments
Strata DK Programming 5/993-163
System & Station
Program 77-2 – Door Phone Busy Signal/Door Lock 
Assignments
Processor Type: DK14, DK40i, All RCTUs
Program Type:Station
Initialized Default:All LEDs are OFF




  6SNU   +ROG  6SNU +ROG 6SNU+ROG 6SNU+ROG
LED/
ButtonXLED ONLED OFF
20One Door Phone Ring Five Door Phone Rings
19——
18——
17——
16DDCB4/HDCB4 B-jack is Lock Control #4 (DK424) B is connected to Door...

System & Station
Program 77-2 – Door Phone Busy Signal/Door Lock Assignments
3-164Strata DK Programming 5/99
Program 77-2 Overview
This program performs three functions:
©Sets number of times door phone rings
©Sets fast busy tone if the called door phone does not exist
©Configures B-pack on DDCB/HDCB output for door lock control
LED 20: Door Phone Ring Count
The number of times that a door phone will ring digital and electronic telephones is set with this 
LED. Light the LED for one ring; turn it OFF for...