Singer Serger Professional 5 Manual
Have a look at the manual Singer Serger Professional 5 Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 50 Singer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Three-Thread Rolled Hem The Rolled Hem Stitch is used to finish edges of scarves, ruffles, table linens, and some garments. It is suitable for lightweight to medium weight fabrics, such as sheers, silkies and broadcloth. Beautiful pintucks c an be achieved with the rolled hem. They can enhance a yoke, heirloom sewing, wearable art and even home decorating projects. Note: Rolled hemming can onl y be performed with the Right Overedge needle all other needles must be removed. Right Overedge Needle Thread Lower Looper Thread Upper Looper Thread Three-Thread Rolled Hem Page 1
ATD: Auto Tension Dial “C” Left Cover Stitch Needle “C” Not Threaded Middle Cover Stitch Needle “D” Not Threaded Right Cover Stitch Needle “E” Not Threaded Upper Looper (Green) Looper Engaged and Threaded Lower Looper (Red) Threaded Chain Stitch Looper (Brown) Not Threaded Upper Looper Clutch “L” Upper Knife Engaged Seam Guide Plate Not Installed Use Knife Cover Seam Width Dial “N” Stitch Length Dial “1” Presser Foot Pressure “N” Differential Feed Dial “N” Stitch Finger “R” Overedge Left Needle “A” Not Threaded Overedge Right Needle “B” (Blue) Threaded Spreader Not Used Set at: Needles: Three-Thread Rolled Hem Page 2
3. Thread the top cover thread guide by pulling the thread towards the left until it slips under the guide. Then pu ll the thread along the right side of the button as illustrated. 4. While holding the thread firmly, pull the thread between the tension disks. 5. Turn the handwheel toward you unt il the lower looper extends 5-10mm (approximately ½ inch ) from the needle plate edge. 6. Thread the looper area of the ma chine following the green color coded thread guides 4-9. Three-Thread Rolled Hem Page 7
7. Thread the hole in the Upper Looper from front to back k. Pull about 4 inches of thread through the loope r and place to the back of the throat plate.