Singer Serger Professional 5 Manual
Have a look at the manual Singer Serger Professional 5 Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 50 Singer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Three-Thread Overedge (wide with decorative thread) Three-Thread Overlock (wide-decorative) page 1 Using decorative threads can duplicate the look of fine braids and bindings often found only in ready-to-wear. It is easy to embellish sewing projects with decorative thread. Threads such as texturized nylon thread, crochet thread, pearl cotton, yarn and more easily slide through the eye of the l ooper. Select soft, flexible threads for best results.
ATD: Auto Tension Dial “B” Left Cover Stitch Needle “C” Unthreaded and Remove Needle Middle Cover Stitch Needle “D” Unthreaded and Remove Needle Right Cover Stitch Needle “E” Unthreaded and Remove Needle Overedge Left Needle “A” (Orange) Threaded Overedge Right Needle “B” Unthreaded and Remove Needle Upper Looper (Green) Looper Engaged and Threaded Lower Looper (Red) Threaded Chain Stitch Looper (Brown) Unthreaded Upper Knife Engaged Seam Guide Plate Not Installed, use Knife Plate Cover Seam Width Dial “N” Stitch Length Dial “2” Presser Foot Pressure “N” Differential Feed Dial “N” Stitch Finger “N” Spreader Disengaged Set-up: Needle: Three-Thread Overlock (wide-decorative) page 2
5. Turn the handwheel toward you until the lower looper extends 5-10mm (approximately ½ inch ) from the needle plate edge. 6. Thread the looper area of the ma chine following the green color coded thread guides 4-9. 7. Thread the hole in the U pper Looper from front to back k. Pull about 4 inches of thread through the loope r and place to the back of the throat plate. Three-Thread Overlock (wide-decorative) page 4
6. Thread the looper area of the mach ine following the red color coded thread guides 4-10. 7. Place the thread slighty from left and to the ri ght of threading guide f. 8. Place the thread slightly from the fr ont and to the back of threading guide g. 9. Place the thread through h, i ,and j. 10. Thread the looper eye (A) from front to back. Pull about 4 inches of thread. Position thread into V cutout (B) on thr eader. Firmly hold thread tail with left hand and pull Threader lever (C) up into place (D). 11. Thread eye of looper. NOTE: Make sure the Upper Looper thread is behind the Lower Looper thread. Three-Thread Overlock (wide-decorative) page 6 “V” cutout Threader Lever
Three-Thread Overlock (wide-decorative) page 8 5. Continue to thread point s 4-8. Slip the thread into the middle slot of the thread guide g. Go over the take up lever h. Continue by slipping the thread into the middle slot of the thread guides i and j. 6. Before threading the eye of the needl e, make sure the thread is behind the thread guide located on the bottom of the needle clamp. 7. Thread the eye of the Left Overedge Needle k. 8. Draw about 4 inches of the thr ead through the needle eye towards the back of the machine. 9. Place the thread to the back, under the Presser F oot. Lower foot and sew.
Chapter 5: Three-Thread Flatlock (narrow and wide)