Sanyo Projector Plc Wxe45 User Manual

Multimedia  Projector 
MODEL PLC-WXE45
Owner’s Manual
 Network Supported 
	 	 □	Wired	LAN
	 	 	 	100-Base-TX/10-Base-T
    * Refer	to	the	owner’s	manual							below	for	details	about	network							function.				■	Network	Set-up	and	Operation 


This	Multimedia	 Projector	is	designed	 with	the	most	 advanced	 technology	 for	portability,	 durability,	and	ease	 of	use.		
This	 projector	 utilizes	built-in	multimedia	 features,	a	palette	 of	16.77	 million	 colors,	 and	matrix	 liquid	crystal	 display	
(LCD)	technology.
Note:
• The On-Screen Menu and figures in this manual may   
  differ slightly from the product.
•The  contents  of  this  manual  are  subject  to  change   
  without notice.
 Lar�e Screen in Limited SpaceLar�e Screen in...


Trademarks
Each	name 	of 	corporations 	or 	products 	in 	this 	book 	is 	either 	a 	registered 	trademark 	or 	a 	trademark 	of 	its	
respective	corporation.
Features and Desi�n  . . . . . . . . . . . . . . .
Table of Contents. . . . . . . . . . . . . . . . . .
To the Owner. . . . . . . . . . . . . . . . . . . . . .4
Safety Instructions
. . . . . . . . . . . . . . . . .5
Air	Circulation	6
Installing	the	Projector	in	Proper	Position	6
Moving	the	Projector	6
Compliance. . . . . . . . . . ....

4
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER 
(OR BACK). NO USER-SERVICEABLE 
PARTS INSIDE EXCEPT LAMP 
REPLACEMENT. REFER SERVICING 
TO QUALIFIED SERVICE 
PERSONNEL.
THIS	SYMBOL 	INDICATES	THAT	DANGEROUS	VOLTAGE	CONSTITUTING	 A	RISK	OF	ELECTRIC	SHOCK	IS	PRESENT 	WITHIN	THIS	UNIT.
THIS	SYMBOL 	INDICATES	THAT	THERE	ARE	IMPORTANT 	OPERATING	AND	MAINTENANCE	INSTRUCTIONS	IN	 THE	OWNER'S	MANUAL	WITH	THIS	UNIT.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
     Safety Precaution...

5
All	the	 safety	 and	operating	 instructions	 should	be	read	 before	
the	product	is	operated.
Read 	all 	of 	the 	instructions 	given 	here 	and 	retain 	them 	for	
later	 use.	Unplug	 this	projector	 from	AC	power	 supply	 before	
cleaning.	 Do	not	 use	 liquid	 or	aerosol	 cleaners.	 Use	a	damp	
cloth	for	cleaning.
Follow	all	warnings	and	instructions	marked	on	the	projector.
For	 added	 protection	 to	the	 projector	 during	a	lightning	 storm,	
or	when 	it 	is 	left 	unattended 	and 	unused 	for...


Movin� the Projector
When	moving	 the	projector,	 replace	the	lens	 cover	 and	
retract	 the	adjustable	 feet	to	prevent	 damage	 to	the	 lens	
and 	cabinet. 	 	When 	the 	projector 	is 	not 	in 	use 	for 	an	
extended	period,	put	it	into	a	suitable	case.
Handle 	the 	projector 	carefully; 	do 	not 	drop, 	bump,	
subject 	it 	to 	strong 	forces, 	or 	put 	other 	things 	on 	the	
cabinet.	
Do	 not	 roll	the	 projector	 more	than	
20	degrees	from	side	to	side.	
Do	not 	point 	the 	projector 	up 	to...

7
Compliance
AC Power Cord for the United Kin�dom:
This	cord	 is	already	 fitted	with	a	moulded	 plug	incorporating	 a	fuse,	 the	value	 of	which	 is	indicated	 on	the	 pin	face	 of	the	 plug.	
Should	 the	fuse	 need	 to	be	 replaced,	 an	ASTA 	approved	 BS	1362	 fuse	must	 be	used	 of	the	 same	 rating,	 marked	 thus ASA.	If	 the	
fuse	 cover	 is	detachable,	 never	use	the	plug	 with	the	cover	 omitted.	 If	a	replacement	 fuse	cover	 is	required,	 ensure	it	is	 of	 the	 same	
colour	 as	that	 visible...

8
Bottom Back
① Antitheft alarm settin� buttons
② Focus Lever
③ Projection Lens
④ Lens Cover 
 (See p. 5 for attachin�)
⑤⑦
⑮
⑫⑬
⑩⑪ CAUTION
Hot 	air 	is 	exhausted 	from 	the 	exhaust	
vent. 	 	Do 	not 	put 	heat-sensitive 	objects	
near	this	side.
③⑥④⑤
Front
⑨
⑧
⑭
 CAUTION
Do 	not	 turn	on 	the 	projector 	with 	putting	
the 	lens 	cover 	on. 	 	The 	light 	beam 	may	
damage 	lens 	cover 	and 	result 	in 	fire	
hazard.
Attach	 the	lens	 cover	 while	the	projector	
is	not	 in	use	 to	avoid...

9
Rear Terminal
S-VIDEO IN
MONITOR  OUTCOMPUTER IN2 /
COMPUTER/COMPONENT
AUDIO  IN
R
VIDEO INL(MONO)
(VARIABLE)
AUDIO  OUT
①②③④⑤⑥
⑧
⑦
⑤ S-VIDEO IN
Connect	the	S-VIDEO	output	from	video	equipment	
to	this	jack	(p.15).
⑥ AUDIO IN
Connect	the	audio	output	from	video	equipment	
connected	to	⑤	or	⑨	to	this	jack.	[When	the	audio	
output	is	monaural,	connect	it	to	L	(MONO)	jack	
(p.15).
⑧ COMPUTER/COMPONENT AUDIO IN 
Connect	the	audio	output	(stereo)	from	a	computer	
or	video	equipment	connected	to	①	or	④	to...

10
Top Panel
①②③
③ LAMP REPLACE indicator
Turn	yellow	 when	the	life	of	the	 projection	 lamp	
draws	to	an	end.		(pp.	57,	64)
② WARNING indicator
E m i t	a 	r e d 	l i g h t 	w h e n 	t h e 	p r o j e c t o r 	d e t e c t s	
a b n o r m a l 	c o n d i t i o n . 	 	T h i s 	a l s o 	b l i n k s 	r e d	
when	 the	internal	 temperature	 of	the	 projector	
exceeds	the	operating	range.		(pp.	54,	64)
① POWER indicator
It	turns	 red	when	 the	projector	 is	in	 the	 stand-by	
mode.		
It	remains	 green	while	the...