Home > Sanyo > Projector > Sanyo LNS W32 Parts Manual

Sanyo LNS W32 Parts Manual

Add to Favourites
    Download as PDF

    View the Sanyo LNS W32 Parts Manual for free. All the Sanyo manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Following checks and confirmations should be taken for safety. Check the following things by the time of the cabinet assembly after the lens replacement. 1. Check the lens is securely fixed. 2. Check no parts is missing, or no mounting part is loose. LCD PROJECTOR LENS MODEL LNS-W32 LENS REPLACEMENT PROCEDURE NOTES ON LENS REPLACEMENT The ZOOM, FOCUS and LENS SHIFT adjustment on the Top Control or the Remote Control cannot be operated with this Lens. Lens replacement should be performed by the qualified...
    Page 2 Fig-1 Fig-2 Fig-3Fig-4 SCREW A Remove 2 screws-A. Press the button (or remove 2 screws-B) on the lower of the front panel and remove the front panel. Remove the light-block sheet from the light- block sheet base. REMOVE THE LENS COVER AND LIGHT- BLOCK SHEET (See Figure-1 and 2)1 1. 2. 2REMOVE THE LIGHT-BLOCK SHEET BASE (See Figure-3 and 4) Perform the stepstofor lens replacement. 15 BUTTON FRONT PANELLIGHT-BLOCK SHEET BASE SCREW B (Some models) LIGHT-BLOCK SHEET BASE First set the lens at the center...
    Page 3 3REMOVE THE LENS (See Figure-5 and 6) Disconnect the Lens Shift connector K16L from the circuit board on cabinet left side. Disconnect the Zoom and Focus connector K16J from the circuit board. Remove the lens motor lead from lead holder. Remove screws-C (4 screws) which fastens the lens and remove the lens. Use the driver (3 mm, Green) included with the lens to remove the screws.1. 2. Be careful not to drop the lens when removing the screws. -3- 3. CONNECTOR K16LLENS MOTORLEAD HOLDER CONNECTOR K16J LENS...
    Page 4 -4- Fig-6 Fig-7 DRIVER IN THE LENS LENS MOUNTING BRACKET 4MOUNT THE LENS (See Figure-5 and 6) 5MOUNT THE LIGHT-BLOCK SHEET AND FRONT PANEL (See Figure-7) Remove protective caps (front and back) on the lens. Mount the lens on lens mounting bracket with 4 screws. Use the driver (4 mm, Yellow) included with the lens to fasten the screws.1. 2. Mount the light-block sheet to the lens as shown in the Figure-7. Use the sheet included with the lens. Make sure the part no. and mark (TOP and BACK) on Light-Block...
    Start reading Sanyo LNS W32 Parts Manual

    Related Manuals for Sanyo LNS W32 Parts Manual

    All Sanyo manuals