Home > Sanyo > Projector > Sanyo LNS-T30KS/W30KS, LNS-T30KB/W30KB Parts Manual

Sanyo LNS-T30KS/W30KS, LNS-T30KB/W30KB Parts Manual

Add to Favourites
    Download as PDF

    View the Sanyo LNS-T30KS/W30KS, LNS-T30KB/W30KB Parts Manual for free. All the Sanyo manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Following checks and confirmations should be taken for safety. Check the following things by the time of the cabinet assembly after the lens replacement. 1. Confirm the lens is securely fixed by 4 screws. 2. Confirm the proper wiring and the wires are fixed properly. 3. Confirm the each connector is connected properly. 4. Wiring must not be tangled in the mechanical parts. 5. There is no missing part, or no loosing mounting part. LCD PROJECTOR LENS MODEL LNS-T30KS/W30KS LENS REPLACEMENT PROCEDURE NOTES...
    Page 2 Remove 4 screws on side cabinet and 1 screw on rear. Grasp the two sides, pull the cabinet top upward and remove. LENS REPLACEMENT PROCEDURE REMOVE THE CABINET TOP (See figure-1)1 1. 2. 2 Fig-1 REMOVE THE CABINET FRONT (See figure-2) Remove 2 screws on cabinet front bottom. Grasp the two sides, pull the cabinet front forward and remove. Remove 2 speaker connectors, LED connector K8K, remote control pre-amp. connector K18D and remove the cabinet front completely.1. 2. 3. Fig-2 3REMOVE THE LED UNIT AND...
    Page 3 Remove 7 screws-A, 2 screws-B and disconnect the 3 FPC cables of LCD panels. Grasp the two sides, pull the Main unit upward. Disconnect the lens motor connector K16S from the circuit board. REMOVE THE LENS MOTOR CONNECTOR (See figure 4, 5)5 1. 2. 3. Fig-4 A A A A AAA B B Cut the wire band and remove the lens motor lead. LENS MOTOR CONNECTOR K16SLENS MOTOR CONNECTOR K16S Fig-5 FPC CABLE REMOVAL CONNECTOR FPC CABLE CABLE LOCK When disconnecting the FPC cable, pull out the cable lock from the connector and...
    Page 4 MOUNT THE CABINET TOP (See figure-9) 1. 2. 8 Fig-9 MOUNT THE MAIN UNIT (See figure-8) Mount the main unit with 7 screws-A, 2 screws-B and connect the 3 FPC cables. Fig-8 9MOUNT THE CABINET FRONT (See figure-8) 10 Remove 4 screws and pull out lens from lens mounting bracket. Be careful not to drop the lens when removing it. REMOVE THE LENS (See figure-6)6 Fig-6 Remove the protective cover on the replacing lens. Insert the lens to the lens mounting bracket and fasten it with the four screws. Use the screws...
    Start reading Sanyo LNS-T30KS/W30KS, LNS-T30KB/W30KB Parts Manual

    Related Manuals for Sanyo LNS-T30KS/W30KS, LNS-T30KB/W30KB Parts Manual

    All Sanyo manuals