Home > Sanyo > Projector > Sanyo LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Manual

Sanyo LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Manual

Add to Favourites
    Download as PDF

    View the Sanyo LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Manual for free. All the Sanyo manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 After the lens replacement (before attaching the top cabinet), check the following things. 1. Check the lens is properly installed. 2. Check no wiring is tangled on the gear of the lens motor or other mechanical parts. 3. Check no parts is missing, or no mounting part is lost. LCD Projector Lens Replacement Procedure Model Number 1AA6P1P5436-- (IFGP) LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Lens replacement should be performed by the qualified service personnel. It should be followed by this procedure...
    Page 2 -2- Lens Replacement Procedure While pressing the Lens release button on the top of the cabinet, turn the lens counterclockwise until it stops and pull it out slowly from the projector. Be careful not to drop the lens. Remove the Lens1 2 Perform the steps 1-2 for lens replacement. First set the lens at the center position with lens shift adjustment. Fig-1-1 LENS RELEASE BUTTON Fig-1-2 Fig-2 Red mark (For A type Cabinet) Mount the Lens 1. Remove the protective caps (front and back) on the lens. 2....
    Page 3 -3- Lens Replacement Procedure 1. Turn the Lens Cover counter-clockwise and pull it toward front to remove the Lens Cover. 2. Remove the two screws (SCREW A) and remove the Top Cabinet. Remove the Lens Cover and the Top Cabinet1 SCREW A LENS COVER TOP CABINET Fig-1-1 Slide the Light-Block Sheet Base upward to remove it. Fig-2 LIGHT-BLOCK SHEET BASE 2 Perform the steps 1-6 for lens replacement. First set the lens at the lowest position with lens shift adjustment. Remove the Light-Block Sheet Base SCREW A...
    Page 4 1. Remove the protective caps (front and back) on the lens. 2. Put the Light-Block Sheet through the lens. (When LNS-W11 is installed, the Light Block Sheet is unnecessary. 3. Insert the lens into the Lens Bracket of the projector as matching the red mark on the lens to that on the Lens Bracket. 4. Turn the lens clockwise until the lens is locked with Lens Lock Lever. Fig-4 Insert the lens into the Lens Bracket as matching these marks. LENS BRACKET -4- 4Mount the Lens Fig-3 Push the Lens Lock Lever and...
    Start reading Sanyo LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Manual

    Related Manuals for Sanyo LNS-S10/LNS-T10/LNS-W10/LNS-T11/LNS-W11 Manual

    All Sanyo manuals