Home > Sanyo > Projector > Sanyo LNS W02/T02 Installation Manual

Sanyo LNS W02/T02 Installation Manual

Add to Favourites
    Download as PDF

    View the Sanyo LNS W02/T02 Installation Manual for free. All the Sanyo manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 PARTS LIST Following parts are contained in the packing. · LENS · LENS MOUNTING SCREWS · DRIVER · LIGHT-BLOCK SHEET · LENS COVER (UPPER · LOWER ) NOTES ON LENS INSTALLATION LCD PROJECTOR LENS MODEL NO. LNS-W02/T02 LNS-W02K/T02K Series Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD...
    Page 2 LENS REPLACEMENT AND INSTALLATION PROCEDURE Remove screws A (2 screws). Pull down the lower lens cover while pushing the part D, then remove it. Remove screws B (2 screws). Remove screws C (2 screws) and remove upper lens cover.1 5Perform the steps tofor lens replacement and installation. 1 1. 2. A Fig-1 Fig-3 lIN CASE OF MODEL WITHOUT LENS Remove 2 screws and pull down the plate. 2 3. 4. UPPER LENS COVER LOWER LENS COVER C B D D COVER PLATE REMOVE THE LENS COVER. (At the step , insert the light-block...
    Page 3 LENS MOTOR LEAD CONNECTOR “ K16B” (D) (D)(D) (D) C LENS MOTOR kFigure shown inside of the cabinet. REMOVE THE LENS. (See figure-4) 1. Remove the connector “K16B” of the circuit board. 2. Loosen the A, B, C wire holder and remove the lens motor lead. 3. Remove screws D (4 screws) which fastens the lens and remove the lens. lIN CASE OF MODEL WITH LENS B ATTACHED DRIVER Fig-5 LENS MOUNTING BRACKET LENS MOTOR LEAD CONNECTOR “K16B” (D) (D)(D) (D) B A LENS MOTORFig-4 This part wiring should not be tightened....
    Page 4 4INSTALL THE LIGHT-BLOCK SHEET. Fig-6 LIGHT-BLOCK SHEET (See figure-6) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) MOUNT THE LENS COVER. (See figure-7) 5 When in install the both upper and lower lens covers, put the light-block sheet through the lens and install the sheet so that it should be placed in the guide slot of the lens cover. (See figure-8) If the installation of the light-block sheet is incorrect, there will be the...
    Start reading Sanyo LNS W02/T02 Installation Manual

    Related Manuals for Sanyo LNS W02/T02 Installation Manual

    All Sanyo manuals