Panasonic Kx-tvs50, Kx-tvs80 Voice Processing System Installation Manual

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
SYSTEM ADMINISTRATORS GUIDE
241
Other Parameters - Intercom Paging Parameter
Intercom Paging is a PBX feature that makes it possible to page the callers party through 
telephone speakers. To utilize this feature, the PBX must have the Intercom Paging feature 
available and the VPS must be properly programmed. This feature is available for APT/DPT 
Integration mode only.To select Rotary Telephone Service, follow the menu path as shown:
System...

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
242SYSTEM ADMINISTRATORS GUIDE
Table 60 
Parameter Value Range
(Default)Description/Function
Intercom 
Paging 
SequenceUp to 12 digits con-
sisting of 0-9, , #
and special codes
(FXW)Specifies the intercom paging sequence required by 
the PBX. It can be programmed using up to 12 of the 
following 8 letters and 12 dial codes.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager...

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
SYSTEM ADMINISTRATORS GUIDE
243
Other Parameters - Fax Management
The VPS can be programmed to automatically transfer incoming fax calls to a fax extension. 
A maximum of 2 fax extensions can be specified as the destination for the Automatic Fax 
Transfer. If the main fax extension is not available to receive a fax, the VPS will transfer the 
fax transmission to the alternate fax extension.Paging Code 
for Group 1-8Up to 12 digits 
consisting of
0-9,...

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
244SYSTEM ADMINISTRATORS GUIDE
Fax No Answer 
Tim e5-60 s
(10)Specifies the length of time (in seconds) the VPS must 
wait before taking other action when there is no answer at 
either fax extension.
Note: This timer applies to the fax call that has been 
transferred to the main or alternate fax extension. 
Fax Manager 
Mailbox No.2-5 digits
(None)Specifies the Fax Manager Mailbox Number. The VPS 
will notify the fax manager of the status of fax calls...

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
SYSTEM ADMINISTRATORS GUIDE
245
Other Parameters - Disconnect Parameter
To select the Disconnect Parameter, follow the menu path as shown:
System Administration Top Menu - 1 - 5 - 7 - 9
Ta b l e  6 2  
Parameter Value Range
(Default)Description/Function
Maximum
Silence Time5-60 s
(10)The VPS will disconnect the call if silence is detected for 
more than the specified time. 

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
246SYSTEM ADMINISTRATORS GUIDE
B7 SYSTEM ADMINISTRATION - HARDWARE 
SETTINGS
For System Administration (system setup, mailbox setup, and system diagnosis) an RS-232C 
terminal must be connected to the serial interface of the VPS.
B7.1 RS-232C Parameters
System Administration Top Menu - 1 - 6
To the RS-232C Parameter, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 1 
Table 63 
Parameter Value Range
(Default)Description/Function
Baud...

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
SYSTEM ADMINISTRATORS GUIDE
247
B7.2 Port Setting
Port Setting Menu
Note
The port assignment procedure for Port 2 is the same as Port 1.To select Port Setting, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2 
To select the Port Setting Menu for Port 1, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2 - 1
Ta b l e  6 4  
Parameter Value Range
(Default)Description/Function
Flash Time 1. 100 ms
2. 300 ms
3. 600...

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
248SYSTEM ADMINISTRATORS GUIDE
B7.3 PBX Interface Parameters
Three separate parameters are used to program the VPS for optimal signaling and performance 
with the PBX.
Dialing Parameters
These parameters specify how the VPS will initiate and control call transfers, setup 
outgoing calls, and control message waiting lamps on extensions. The procedure for 
verifying the correct code sequences for non-Panasonic KX-T series telephone systems is 
to manually...

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
SYSTEM ADMINISTRATORS GUIDE
249
Table 66 
PBX Type Other
ManufacturersKX-T series
T308/
T616T1232 T96 T336TD816/1232/
308TA series
Integration 
ModeNone
NoneNone None None None
*1DPTNone*2APT
Inband Inband Inband Inband Inband Inband
Operator 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX
Extension 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX
Alternate 
Extension 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX
Reconnect 
Sequence on 
BusyFWW...

B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
250SYSTEM ADMINISTRATORS GUIDE
*1When your KX-TD series telephone system is in DPT Integration mode.
*2When your KX-TA624 telephone system is in APT Integration mode.
N/A Not available
—Not needed
Table 67 
Parameter Value Range
(Default)Description/Function
Integration 
Mode1. None
2. Inband
3. APT
4. DPT
(TVS50: APT
TVS80: DPT)Specifies the method of integrating the VPS with the 
PBX.
1. None - Both PBX and VPS work independently, 
without accessing...