Panasonic Cpc+AII/B Digital Business System Release Notes Manual

Section 700 - OperationChapter 2. System Features
Terminal, Distributed and Longest Idle Hunting
(CPC-AI1 and CPC-B Version 2.0 or higher)
Beginning with CPC-B Version 2.0, three types of hunt groups are available:
Terminal, Distributed, and Longest Idle. 
In addition, CPC-Al1 and CPC-B
Version 2.0 and higher also provide a software-defined pilot extension
number. The software-defined pilot number eliminates the need for the 2 W
450 Ohm resistor required for a pilot number in CPC-A and CPC-B Versions...

Chapter 2. System FeaturesSection 700 - Operation
lFF4 (Ringing and Hunt Groups): Hunt .Group Transfer Timer
lFF4 (Ringing and Hunt Groups): Hunt Group Extension Number
lFF4 (Ringing and Hunt Groups): Transfer Extension Number
lFF4 (Ringing and Hunt Groups): CO Delayed Day Ring Assignments for
Hunt Group Pilot Numbers
lFF4 (Ringing and Hunt Groups): CO Delayed Night Ring Assignments for
Hunt Group Pilot Numbers
lFF4 (Ringing and Hunt Groups): Central Office Day Ring Assignment for
Hunt Group Pilot...

Section 700 - OperationChapter 2. System Features
forwarding set, unless call forwarding is set to an outside number. In
previous versions, hunting would skip an extension with call forwarding
set. The following call types will hunt to a member that has call forwarding
set:
- Intercom calls
- Transferred intercom cal Is
- Incoming CO calls (including DID calls)
- Transferred CO calls
- DISA calls
Station Message Detail Recording
(SMDR)
(All Versions)
Description
Station Message 
DetaiLRecording (SMDR)...

Chapter 2. System FeaturesSection 700 - OperationFigure 2-2. 
SMDR Formut for CPC-AII and CPC-B Version 3.1 or higher
0123456701234567890123456789012345678901234567~901234567~9012345679901234567
12345678 9
T MM/DD HH:NM:SS HH:MM.SS NNN DDDDDDDDDDDDDDDDDDDDDDDDDDDD AAAAAAAAAA VVWV NN
l=Call type
S=Inbound DISA
s=Outbound DISA
I=Incoming
o=Outgoing
T=Transfer (See Note 1.1
N=DNXS
D=DID
2=Date
MM=month
DD=day
3=Call start time
HH=hours
M&minutes
SS=seconds
4=Call duration
HH=hours
MM=minutes
SS=seconds...

Section 700 - OperationChapter 2. System Features
Figure 2-3. SMDR Format for CPC-A and CPC-B Versions Prior to 3.1
01
234
567
0~234567890123456789012345678901234567890123456789012345678901234567890
123 4 56
7a
Ml4 DD HH:MM H:MM.X C NNDDDDD-DDD-DDD-DDDDNNNAAAAAAzlAAA
l=DateS=Trunk number
M&monthNN=number (01-64)
bD=day
C=Dialed digits
2=Call start timeDD=digits O-9 or symbols l or#
H&hour(See the Note following item 8.)
MM=minute
3=Call duration
&hour (O-9)
MM=minutes
X=l/lOth of a minute (O-9)
4=Call...

Chapter 2. System FeaturesSection 700 - Operation
Tl Interface
(CPC-B Version 4.0 or higher)
DescriptionThe 
Tl Interface is a digital trunk card that provides twenty-four 64 kbps
channels, for a total transmission rate of 1.544 Mbps. 
Tl lines can be leased
from local exchange carriers and long-distance carriers.
The DBS 
Tl Interface supports the following options:
SF or ESF Framing FormatsEither super frame (SF) or extended super frame (ESF) formats can be used
with the DBS 
Tl.The superframe consists...

Section 700 - OperationChapter 2. System Features
- 1 Tl Trunk Card (VB-43561
- 1 Tl MDF Card (VB-43562)
- 1 Sync Card (VB-43563).
In addition, one 
Tl Cable (VB-43564) is required to install a Tl in a double
cabinet if the 
Tl card is located in the slave cabinet.
To install two Tls in a double cabinet, you must have 2 
Tl Trunk Cards and
2 
T1 MDF Cards.
lThe installer must provide a Channel Service Unit 
(CSU) that complies
with FCC Part 1.5 and Part 68. The CSU is installed between the DBS and
the...

Chapter 2. System FeaturesSection 700 - Operation
Telephony Services
(CPC-AI1 Version 7.0 and higher and CPC-B Version7.0 and higher)
DescriptionComputer Telephony Integration (CTI) provides communication and
coordination of operation behveen computers and the telephone system. One
of the most significant emerging standards in 
CTI is the Telephony Services
Appiication Programming Interface from Novell@.
Telephony Services is basically a third party call controller. Applications
designed for Telephony...

Section 700 - OperationChapter 2. System Features
Novell
Telephony
ServerNovell Network
Outslde CO
Trunk Lines
4
DBS
SerialCommunication
Line
API Port
Telephone Extensions
Related Programmingl 
FFl (System): API Port Type
l 
FFl (System): API Baud Rate
Hard ware Requirements
lVB-43941 Telephony Services Kit. This kit includes a Panasonic API
Card, the API Serial Connector (two ports) and one 3 
l/2” floppy disk
containing the Telephony Services DBS Driver 
“Panadivr.”lA Novell 3.12 (or later), 486 (or...

Chaoter 2. Svstem FeaturesSection 700 - ODeration
Toll Restriction
(All Versions)
Des&p tionAccess levels, including the prohibition of long distance calls or after-hours
calls, can be assigned to specific extensions or CO lines using the Toll
Restriction feature. This minimizes non-business related calls and reduces
phone bills by only allowing long distance calls over designated lines.
The following access levels are available:
Table 2-2.Toll Restriction Types
Toil RestrictionCharacteristics
Type...