NEC Neax2000 Ivs Feature Programming Manual

CHAPTER 2 ND-45670 (E)
Pag e 3 10
Revision 2.0
MUSIC ON HOLD
To provide External Hold Tone Source through PN-TNT Card (1200 Series Enhancement):
To provide External Hold Tone Source through PN-CP03 Card (1500 Series Enhancement):
DESCRIPTION DATA
Assign the TNT Circuit No. (External Hold 
Tone Source No. ) to the required LEN.(1) LEN (0000-0511)
(2) DA00-DA09: TNT Circuit No.
Note
Note:
The TNT Circuit No. must be as-
signed to the first LEN (Level 0)
and/or the third LEN (Level 2) of
each LT slot.
The...

ND-45670 (E) CHAPTER 2
Page 311
Revision 2.0
MUSIC ON HOLD
HARDWARE REQUIRED
To provide External Hold Tone Source through PN-4COT and PN-DK00 card:
•PN-4COT
• PN-DK00
• External Hold Tone Source provided locally
Make the following connections between the trunks and the External Hold Tone Source at the MDF.
For details, refer to the MDF cross connection for an External Tone Source in the INSTALLATION PROCEDURE
MANUAL.
To provide the Hold Message by Digital Announcement Trunk:
• P N - 2 D ATA
PN-DK00 CARD...

CHAPTER 2 ND-45670 (E)
Pag e 3 12
Revision 2.0
MUSIC ON HOLD
To provide the External Hold Tone Source through PN-TNT card:
•PN-TNT
• External Music Source provided locally
To connect the External Hold Tone Source, plug the cable into JACK0 or JACK1 on the PN-TNT card.
Set the switches on the PN-TNT card to adjust the External Hold Tone Source level.
• Level Control of External Hold Tone Source through JACK0/JACK1
No. 0 CIRCUIT (JACK0) No. 1 CIRCUIT (JACK1)
OUTPUT LEVEL SW-1 SW-2 OUTPUT LEVEL SW-3
SW-4...

ND-45670 (E) CHAPTER 2
Page 313
Revision 2.0
MUSIC ON HOLD
To provide External Hold Tone Source through PN-CP03 card:
• External Hold Tone Source provided locally.
To connect the External Hold Tone Source, plug the cable into JACK on the PN-CP03 card.
Set the switches on the PN-CP03 card as follows.
To provide Hold Tone Source on the MP card:  Set the JP1 switch to UP.
JAC K PN-CP03 CARDPBX
EXTERNAL HOLD TONE SOURCE
JP1
PN-CP03 CARD
VR
JP1:INTERNAL/EXTERNAL 
HOLD TONE
 SOURCE
VR:VARIABLE RESISTOR FOR...

CHAPTER 2 ND-45670 (E)
Pag e 3 14
Revision 2.0
NIGHT SERVICE: ATTENDANT NIGHT TRANSFER
PROGRAMMING 
DESCRIPTION DATA
Provide the system with Attendant Night 
Transfer. (1)  018: Attendant Night Transfer 
(2)  1 : To be provided 
Assign the Night Connection Station to each 
ATTCON Group. •  YY = 13
(1) ATTCON Group 0-3 (00-03) assigned 
by CM60 YY = 00 
(2) X-XXXX: Night Connection Station 
No.CM08 START
END
CM51 

ND-45670 (E) CHAPTER 2
Page 315
Revision 2.0
NIGHT SERVICE: CALL REROUTING
PROGRAMMING 
Refer to Night Connection-Fixed/Flexible, Trunk Answer Any Station, Direct Inward Termination (DIT), Direct In-
ward Dialing (DID), and E&M Tie Line Access.  

CHAPTER 2 ND-45670 (E)
Pag e 3 16
Revision 2.0
NIGHT SERVICE: DAY/NIGHT MODE CHANGE BY ATTENDANT CONSOLE
PROGRAMMING
Note:The following trunk data (CM30) can be changed by this feature (depending upon programming).
Day (YY)
Night (YY)
02 03
04 05
13 14
15 16
30 31
DESCRIPTION DATA
Assign the password code for Day/Night 
Change by SN610 ATTCON.•  YY = 30
(1) 1 
(2)  XX-XX: Password Code (Max. 8 dig-
its)
X: 0-9, A(*), B(#)
If no data is set, the default setting is
NONE. In this case, the password is set...

ND-45670 (E) CHAPTER 2
Page 317
Revision 2.0
NIGHT SERVICE: DAY/NIGHT MODE CHANGE BY STATION DIALING
PROGRAMMING 
Note:The following trunk data (CM30) can be changed by this feature (depending upon programming).
Day (YY)
Night (YY)
02 03
04 05
13 14
15 16
30 31
DESCRIPTION DATA
Provide the system with Day/Night Mode 
change by Station Dialing. (1)  244:  Change of Terminating System 
Incoming Trunk (CM30, YY = 
02/03) 
(2) 0: Available
(1)  245:  Change Trunk Restriction Class 
(CM30 YY = 02/03) 
(2) 0:...

CHAPTER 2 ND-45670 (E)
Pag e 3 18
Revision 2.0
NIGHT SERVICE: NIGHT CONNECTION-FIXED
PROGRAMMING
To Provide Night Connection Stations.
DESCRIPTION DATA
Assign a Night Connection Station to each 
Incoming Trunk.•  YY = 03
(1) Trunk No. (000-255) 
(2)  04: Direct-In Termination
•  YY = 05
(1) Trunk No. (000-255) 
(2)  X-XXXX: Night Connection Station 
No.
Assign the destination to which a call is 
forwarded when the Night Connection 
Station is Busy/No Answer.•  YY = 14 (When Night Connection 
Station is...

ND-45670 (E) CHAPTER 2
Page 319
Revision 2.0
NIGHT SERVICE: NIGHT CONNECTION-FLEXIBLE
PROGRAMMING 
Refer to Night Connection-Fixed and Call Forwarding-All Calls.