Multi-Tech Systems Mvp-2400/2410/3010, Mvp-210/410/810 Voice/ip Gateways User Guide

MultiVOIP User Guide Quick Start Instructions
51
Sample Phonebooks Enlarged
Boise Voip Boise VoipInbound Phonebook Outbound PhonebookPrefix to
RemovePrefix
to AddDescription
Incoming CallsDestin.
PatternTo ta l
DigitsPrefix to
RemovePrefix
to AddIP
AddrDescription
Outgoing Calls
1208 9, Incoming calls
to PSTN,
Boise Area91505 12 9 none204.
16.49.
74Outgoing calls
to Santa Fe
area
120833327 7 Incoming calls
to extensions
of company’s
PBX system
in Boise2 3 none 1505
444
3204.
16.49.
743-digit calls to...

Quick Start Instructions MultiVOIP User Guide
52
Phonebook Worksheet
Voip Location/ID:____________________________
Inbound PhonebookOutbound PhonebookPrefix to
RemovePrefix
to AddDescription
Incoming CallsDestin.PatternTo t a lDigitsPrefix toRemovePrefixto AddIPAddrDescriptionOutgoing Calls
Other Details:
Voip Location/ID:____________________________
Inbound PhonebookOutbound PhonebookPrefix to
RemovePrefix
to AddDescription
Incoming CallsDestin.PatternTo t a lDigitsPrefix toRemovePrefixto...

MultiVOIP User Guide Quick Start Instructions
53
Enlarged Phonebook Worksheet 

Quick Start Instructions MultiVOIP User Guide
54
Connectivity Test
The procedures “Phone/IP Starter Configuration” and “Phonebook
Starter Configuration” must be completed before you can do this
procedure.
1. These connections must be made:
Connections
for digital MultiVOIPs
(MVP-2400/2410/3010for analog MultiVOIPs
(MVP-210/410/810)
MultiVOIP to local PBX MultiVOIP to local phone
station
 –OR--
MultiVOIP to extension of
key phone system
MultiVOIP to command PC MultiVOIP to command PC
MultiVOIP to Internet...

MultiVOIP User Guide Quick Start Instructions
55
6. Use HyperTerminal  to receive and record console messages from the
MultiVOIP unit.  To do so, set up HyperTerminal as follows (setup
shown is for Windows NT4; details will differ slightly in other MS
operating systems):
  In the upper toolbar of the HyperTerminal screen, click on
the Properties button.
  In the “Connect To” tab of the Connection Properties
dialog box, click on the Configure button.
  In the next dialog box, on the “General” tab, set...

Quick Start Instructions MultiVOIP User Guide
56
8.  Read console messages recorded on HyperTerminal.
Console Messages from Originating VOIP.  The voip unit that
originates the call will send back messages like that shown below.
[00026975]  CAS[0] : RX : ABCD = 1, 1, 1, 1,Pstn State[1]
TimeStamp : 26975
[00027190]  CAS[0] : TX : ABCD = 1, 1, 1, 1
[00027190]  PSTN: cas seizure detected on 0
[00027440]  CAS[0] : TX : ABCD = 0, 0, 0, 0
[00033290]  PSTN:call detected on 0 num=17637175662*
[00033290]...

MultiVOIP User Guide Quick Start Instructions
57
Console Messages from Terminating VOIP.  The voip unit connected
to the phone where the call is answered will send back messages like
that shown below.
[00170860]  H323[0]: New incoming call
[00170860]  PSTNIF : Placing call on channel 0  Outbound
digit 7175662
[00170885]  CAS[0] : TX : ABCD = 1, 1, 1, 1
[00171095]  H323IF [0]: MasterSlaveStatus=Master
[00171105]  CAS[0] : RX : ABCD = 1, 1, 1, 1,Pstn State[7]
TimeStamp : 171105
[00171105]  H323IF[0]: Coder...

Quick Start Instructions MultiVOIP User Guide
58
Troubleshooting
If you cannot establish connectivity between two voips in the system,
follow the steps below to determine the problem.
1. Ping both MultiVOIP units to confirm connectivity to the network.
2. Verify the telephone connections.
A. For MVP2400, MVP2410, or MVP3010.
Check cabling. Are connections well seated?  To correct receptacle?
Is the ONL LED on?
 (If on, ONL indicates that the MultiVOIP is online on the
network.)
Are T1/E1/PRI Parameter...

59
Chapter 3: Mechanical Installation
and Cabling 

Mechanical Installation & Cabling MultiVOIP User Guide
60
Introduction
The MultiVOIP models MVP210 and MVP2400 are table-top units and
can be handled easily by one person.  However, the MVP410, MVP810,
MVP2410, and MVP3010 are somewhat heavier units.  When these
units are to be installed into a rack, two able-bodied persons should
participate.   
Please read the safety notices before beginning installation.
Safety Warnings
Lithium Battery Caution
A lithium battery on the voice/fax channel board provides...