Multi-Tech Systems Mvp-2400/2410/3010, Mvp-210/410/810 Voice/ip Gateways User Guide

MultiVOIP User Guide Software Installation
81
8. A completion screen will appear.
Click Finish.
9. When setup of the MultiVOIP software is complete, you will be
prompted to run the MultiVOIP software to configure the VOIP.
Software installation is complete at this point.  You may proceed with
Technical Configuration now or not, at your convenience.
Technical Configuration instructions are in the next two chapters of
this manual:  Chapter 5 for T1/E1 MultiVOIP units and Chapter 6 for
Analog MultiVOIP units. 

Software Installation MultiVOIP User Guide
82
Un-Installing the MultiVOIP Configuration
Software
1. To un-install the MultiVOIP configuration software, go to Start |
Programs and locate the entry for the  MultiVOIP program.  Select
Uninstall. 

MultiVOIP User Guide Software Installation
83
2. Two confirmation screens will appear.  Click Yes and OK when you
are certain you want to continue with the uninstallation process.
3. A special warning message similar to that shown below may appear
concerning the MultiVOIP software’s “.bin” file.  Click Yes. 

Software Installation MultiVOIP User Guide
84
4. A completion screen will appear.
Click Finish. 

86
Chapter 5: Technical Configuration
for Digital T1/E1 MultiVOIPs
(MVP2400, MVP2410, MVP3010) 

MultiVOIP User Guide Technical Configuration (Digital Voips)
87
Configuring the Digital T1/E1 MultiVOIP
There are two ways in which the MultiVOIP must be configured before
operation:  technical configuration and phonebook configuration.
Technical Configuration.  First, the MultiVOIP must be configured to
operate with technical parameter settings that will match the
equipment with which it interfaces.  There are seven types of technical
parameters that must be set.
These technical parameters pertain to...

MultiVOIP User Guide Technical Configuration (Digital Voips)
88
Remote configuration is done through a connection between the
MultiVOIP’s Ethernet (network) port and a computer connected to the
same network.  The computer could be miles or continents away from
the MultiVOIP itself. There are two ways of doing remote configuration
and operation of the MultiVOIP unit: (1) using the MultiVoipManager
SNMP program, or (2) using the MultiVOIP web browser interface
program.
MultiVoipManager.  MultiVoipManager...

MultiVOIP User Guide Technical Configuration (Digital)
89
Local Configuration
This manual describes local configuration only.  For information on
remote configuration and management, see the MultiVoipManager
documentation.
Pre-Requisites
To complete the configuration of the
MultiVOIP unit, you must know several
things about the overall system.
Before configuring your MultiVOIP Gateway unit, you must know the
values for several IP and T1/E1 parameters that describe the IP
network system and telephony...

MultiVOIP User Guide Technical Configuration (Digital Voips)
90
T1 Telephony Parameters (for MVP2400 & MVP2410)
The following parameters must be known about the PBX or telco
central office equipment to which the T1 MultiVOIP will connect:
➼
T1 Phone Parameters
Ask phone company or
PBX maintainer.
Info needed to operate:
MVP2400
MVP2410
T1 Telephony Parameters:
Record for this VOIP Site


• Which frame format is used?  ESF___ or  D4___
• Which CAS or PRI protocol is used? ______________
• Clocking: Does...