Mitel Voice Processing Solutions Installation And Service Manual

3. Enter N to select Day/Night Menu:Day/Night Menu
(3Start time of the workday (hh:mm [am/pm]) [O&o0 AM]
(E)End time of the workday (hh:mm [am/pm]) [OS:00 PM]
(W) Weekend Days (Monday thru Sunday) [DN][DDDDDNN](X) Exit
3 Make any required changes from the default settings. Enter X to Exit back to the
In-band Application menu.
4. Enter D to select Dialing Plan Menu:Dialing Plan
(D) Dialing plan 
- [3,3,3,3,3.3.3.3.3](E) Optional Star Prefix Dplan(X) Exit
3 Make any required changes from the default...

8.Enter P to select the Passcode Menu:
Passcode Menu_ __________ ____._ . .(M)Minimum 
Passcode Length - [4](N)Maximum Passcode Length - [ 101(C)Passcode Trip Count - [5](P)Passcode Trip Period - [24](X) Exit
3 Make any required changes from the default settings. Enter X to Exit back to the in-band
Application menu.
9.Enter R to select the Receptionist menu:Receptionist
_------_-.___._
(D)Dialing Plan OptionsO=)Flow Options
(P)PBX Dial String Definitions(T)Trunk /Extension Treatment Types
(X) Exit...

12.Enter 2 to select the Default Options Menu:Default PBX Options Menu
----------------_--__________________
(A)Post Directory number dial string [+](B)Pre Directory number dial string / Attendant xfer string [S+]
(C)Connect Dial string on Called Party Accept [J(E)Dial string for Return on Called Party Refused [++]
(F)Dial string for Return on Called Party Busy [S+](G)Special actions on Reorder Tone Encountered [OH]
(H)Dial string for Return on Called Party RNA [S+](X) Exit
13.Enter A to select the Post...

14.Enter X to save changes and return to the VoiceMemo Configuration - Main Menu:Writing new configuration report to 
/usr/vm/config/vm.report.0vmcmd-update: performing ‘cp lusrlvmiconfigivm.report.0 /usr/vm/config/vm.report
15.Enter X three additional times to exit back to the Main Menu.COMMAND (M/C/R/S/X):
(Press Enter key to expand menu)(c) All Software Copyright 1983. 1995 Centigram Comm. Corp. All Rights Reserved.HOST: I
STATUS: 
ENAOS VSN : 4.22CMEMORY : 04860/ 16000
LOG DATA: Y
Disk0 Disk 1 Disk 2...

3 Enter the number of the group to display (3 in this example):Enter Group Number to Display (i-24) or 
 for all: 3SYSTEM CONFIGURATION
Fn Apr 26 134624 1996
Group 
#3: “Enhanced In-Band ”
Lines 3:0 3: 1Application 
= [ENHANCED IN-BAND]
Dial plan - [3,3,3,3,3,3,3,3,3]Administrator mbox # = [998]General Greeting mbox # = []Attendant mbox # = [999]Wait Prompt = [Y]
Caller multiple messages enabled 
= [Y]
KEY-O for attendant transfer during greeting = [N]
Disconnect string = []Pre-company name string =...

.’
‘..
TCP/IP System Wide Host Configuration
Domain name: software
HCMS
oaolNsrdoe
tdettIP AddressHost NamePort Irq Vendor
1 
I P 1 3 134.199.54.147oneview 0280 IO ALTA #Iost CardGateway AddressSubnet Mask Broadcast Address1 
I134.199.54.25 I 255.255.255.0
SMARTCARD TABLE
host card port-name cpuowner
The following optional features are enabled:
Analog Networking
Receptionist
Networking
FaxMemoEnhanced In-band
TCPIIPOneViewCall Agent
Disk Redundancy
134.199.54.255
intr addr
Prompt Language Configuration:...

6.5.Test the Application
1. Set up a telephone to call forward on Busy, or No-Answer, to the abbreviated number
chosen to send callers to voice mail.
(Refer to Section 
58.1 Message Forwarding Abbreviated Dial Number, on page 8).
2. Call the telephone and let it ring No-Answer.
* Check that the call goes to voice mail and the correct No-Answer greeting plays.
3. Take the telephone off-hook to put it in Busy condition, and call it again
3 Check that the call goes to voice mail and the Busy greeting...

7.CONSOLE AND REMOTE ACCESS TO MITEL MAIL
This procedure shows how to connect the console and the modem to the IMITEL MA/L system.
7.1.Console Setup
The console uses a 9 to 25 pin NULL MODEM RS-232 cable, included with the system.NOTE:
You MUST use a NULL modem cable, or a straight-through cable with a NULL
modem adapter, for console connection (see Figure 3 on page 33).l
Connect the g-pin cable connector to COMl (designated console in M/TEL MAIL
system software).l
Connect the 25pin cable connector to...

pho”y /p-------AFt.9232 Straight through cable
fI
Phone Line !
I
-Modem
L!
clWorkstation
NULL Modem 
RS232 cable
PPone Line
iRemote
RS232 Straight through cable
\ RS232 Straight through cable
m COMZ
MITEL MAIL
Figure 
3 - Console and Remote Maintenance Connection to MITEL MAIL
33 

Issue 1 Release 2.0 January 19961Voice Processina Solutions 1
PBX IntegrationTM, 
@ -Trademark of Mite1 Corporation
0 Copyright 1996, Mite1 Corporation
All rights reserved.
Printed in Canada.
SX-ZOOPPABX
MITELa..‘.$,:.:‘:.“~y;: .:.:. :. .j ::: ‘. .:. . . . . .:: ..:i.“‘.1.:. ::::. .-:.:
.I :..:
:.:.“:..:’,,