Mitel Voice Processing Solutions Installation And Service Manual

DP 7501Page 6 of 6
VoiceMemo Release 5.03 and later
stebReference35. Compare your templates with your worksheet to verify your work.
Select:(0) Show Application
Response: The system scrolls all of the templates in the application onto the
console screen.If any of the information does not match your
worksheet, select the template and make the necessary changes.
36. Backup (save) the application.
Select:(H) Backup Application (Release 5.03 systems) or
(S) Save Application (Release 5.04 systems)
Prompt:Do...

Appendix A:Fujitsu Starlog Enhanced In-band IntegrationThis appendix contains supplemental information about integrating an 
AIP
VoiceMemo system with a Fujitsu Starlog PBX. See the Task List for procedures to
configure the integration.
Features and FunctionsThe 
Starlog PBX uses a hunt group to route internal and external calls to the
VoiceMemo system. When the switch sets up a call to the VoiceMemo system, it
directs the call to the hunt group pilot. The pilot is a “phantom extension,” and is
always...

Fujitsu Statlog
lDTMF-to-PBX Message Waiting (Type 3) - uses VoiceMemo line ports
to pass DTMF message waiting requests to the PBX.
0Pager and Message Delivery Message Waiting (Type 5) - uses one or
more 
VoiceMemo line ports to outdial to external paging systems or
telephone numbers.
Starlog PBXIncoming
Trunks,DILs\
StationForwarding
Message
Retrieval
‘4- - ) Queue-
7//Circular
Hunt Group
ou;f;k~- ---------
t
-
-
AIP VoiceMemo SystemIntegration Ports
I
a-1 MODEM
Message Waiting 
Port(s+---------....

Fujitsu StarlogThe Fujitsu 
Starlog software requirements are:
0Feature Package Fl or higher
The 
Starlog hardware requirements are:
0One (1) 8SLC port per VoiceMemo/Receptionist port
l
One (1) 
8SLC port for message wait control
Feature Interactions and limitations
lIn Starlog systems with three- and four-digit extension numbers, the PBX will
insert a lead digit 0 to fill three-digit numbers out to four digits. The EIB
software has templates set to accommodate sites with thre&-digit, four-digit, and...

Fujitsu Statlog
0Program the VoiceMemo ports to dial a DTMF # when the system
identifies a call forwarded from one of its own ports.
0Set line exception 9 for ringing timeout to be greater than the Starlog’s
Forward No Answer timer.
See the Receptionist 
II Manual for more information about programming for
Receptionist II.
VoiceMemo Template SpecificationsThe 
Starlog templates have a default inter-digit timeout of 2 seconds and are set to
hangup on an error condition. Without actually editing the...

Fujitsu Starlog
T8:
Next:
Comment:
T9:
Next:
Comment:
TlO:
Next:
Comment:
Tll:
Next:
Comment:
T12:
Next:
Comment:
T13:
Next:
Comment:
T14:
Next:
Comment:
T15:
Next:
Comment:
T16:
Next:
Comment:
T17:
Next:
Comment:
T18:
Next:
Comment:
T19:
Next:3 
sx# 0 dx#, V4, 20, H
Busy forwarded call:Stuffed 0 in destination
3 
sx# dx#, V4, 20, H
Busy forwarded call: No stuffed digits4 
0 sx# 0 dx#, V3, 20, H
RNA forwarded call:Stuffed 0 in source and
destination4 
0 sx# dx#, V3, 20, H
RNA forwarded call:Stuffed 0 in...

Fujitsu Starlog
Comment:Busy forwarded external call: No stuffed digit in
destination
T20:
9 Xx# 0 dx#, V3, 20, H
Next:Comment: 
RNA forwarded external call: Stuffed 0 in
destinationT21: 
9 Xx# dx#, V3, 20, H
Next:Comment: RNA forwarded external call: No stuffed digit in
destinationT22: 0 Xx# 0 dx#, V2, 20, H
Next:
Comment:Forward ALL forwarded external call: Stuffed 0 in
destination*.T23: 0 
Xx# dx#, V2, 20, H
Next:Comment: Forward ALL forwarded external 
call:No stuffed
digit in destination
A-G 

Appendix B:Omni Enhanced In-band IntegrationThis appendix contains supplemental information about integrating an 
AII?
VoiceMemo system with an Omni PBX. See the Task List for procedures to
configure the integration.
Features and FunctionsThe Omni integration operates over standard two-wire E 
& M trunk circuits. The
switch routes direct and forwarded calls to the 
VoiceMemo afiplication over one
group of trunks.Th
eVoiceMemo system sends message waiting requests to the
switch over a separate trunk (or...

OmniOMNI SI, Sill PBXAIP VoiceMemo System
Incoming
Trunks 
-IStation 
--IForwarding
Message
Retrieval
--
1 $Queue*--?f
1’Dummy
)ExtensiontCircular
--IHunt Group
fIntegration PortsB
IB
tI
.2-WireE&M Tie Trunks -Message Waiting 
Port(s1
Outdial Ports1Enhanced In-band
and Receptionist II
Applications
DTMF to PBX
Message Waiting
Outdials:
Paging, Fax,
Call Placement
Figure B-l Omni to 
VoiceMemo System Integration Structure
The 
AU’ VoiceMemo system has two types of message waiting notification that you
can...

Omni
0One line card port for DTMF to PBX message wait control
0Additional line card ports to place any outgoing calls (paging, fax, etc.)
The Omni software requirements are:
lRelease 52.40 or later (SI)
lRelease 82.40 or 85.10 or later (SIII)
The Omni hardware requirements are:
lOne (1) 2-wire E & M trunk per VoiceMemo/Receptionist port
0One (1) 2-wire E & M trunk for message wait control
Feature Interactions and limitations’
lOmni FeaturePhones use the Message Leave-feature for message waiting...