Mitel SX-200 DIGITAL Pabx Information Manual

Shipping, Receiving, And installation Information 
CHART 5-16 
INSTALL MAINTENANCE TERMINAL INTO SX-200@ CABINET 
Step 
1. Action Comments 
Unpack and install the maintenance terminal 
Set terminal BAUD rate to 9600 
(VT-100 or equivalent) in its assigned 
position. 
2. Connect an RS-232 cable between the 
terminal and the local port on the 
maintenance panel on the front of the 
system. The maximum length of the RS-232 
cable is 15 m (50 ft). 
3. If installing a remote terminal, connect a 
modem to the...

Shipping, Receiving, And installation Information 
TABLE 5-l 
MAINTENANCE PANEL RS-232 CONNECTOR PIN ASSIGNMENTS 
W-232 
pin RS-232 
signal DCE 
data communication equipment 
[local (dte) port] DTE 
data terminal equipment 
[remote (dce) port] 
2 DATA RX TX 
3 DATA TX RX 
4 READY TO SEND i/P 
5 CLEAR TO SEND O/P 
6 DATA SET READY O/P O/P 
I/P 
I/P 
7 SIG. GROUND 
8 CARRIER DETECT O/P (not used) 
I/P (not used) 
20 DATA TERMINAL READY I/P (not used) 
O/P 
TABLE 5-2 
MAINTENANCE PANEL RS-232 CONNECTOR...

Shipping, Receiving, And Installation Information 
REMOTE - DEDICATED, PUBLIC NETWORK 
RX 
TX TERMINAL 
C---A 
REMOTE - DIAL-UP 
PAIR 
,,....CCT FOR AUTO-ANSWER 
MODEM. TO DPABX VIA 
CENTRAL OFFICE 
T=L  
REMOTELY LOCATED 
TERMINAL 
NOTE: The Auto-Answer MODEM is 
permanently connected to one 
local station circuit (extension). 
7707ROEl 
Figure 5-14 Maintenance Terminal Connections - SX-200@ Cabinet 
Page 5-37  

Shipping, Receiving, And Installation information 
CHART 5-17 
INSTALL MAINTENANCE TERMINAL INTO SX-200@ UNIVERSAL CABINET 
Step 
1. 
Action Comments 
Unpack, inspect, and install the maintenance Set terminal BAUD rate to 9600 
terminal (VT-100 or equivalent) in its 
assigned position. 
2. Connect an RS-232 cable between the 
terminal and the port on the maintenance 
panel. Set switch to DTE. Maximum RS-232 cable length is 15 
m (50 ft) 
3. If installing a remote terminal, connect a A modem may be...

Shipping, Receiving, And Installation Information 
REMOTE 
- DEDICATED, PUBLIC NETWORK 
DEN! 
REMOTELY LOCATED 
TERMINAL 
REMOTE - DIAL-UP 
TO DPABX VIA 
CENTRAL OFFICE 
3 - ;I,, 
0 
- 
MODEM 
REMOTELY LOCATEC 
TERMINAL 
AUTO-ANSWER 
CONNECT 
MODEM. 
NOTE: The Auto-Answer MODEM is 
permanently connected to one 
local station circuit (extension). 
KAOlB7ROEO 
Figure 5-15 Maintenance Terminal Connections - SX-200@ Universal Cabinet 
Page 5-39  

Shipping, Receiving, And Installation Information 
Step 
1. 
2. 
3. 
4. 
CHART 5-18 
INSTALL ATTENDANT CONSOLE 
Action 
Unpack console and place it in position at 
Attendant workstation. 
Comments 
Refer to Figure 5-16. 
Connect headset (or handset) to its cord, and 
plug cord into jack at side of console. 
Plug the console modular cord into the jack 
at the back of the console and into its 
assigned modular telephone jack. The two jacks are in parallel; either 
may be used. 
Jack is marked LINE PORT....

Shipping, Receiving, And Installation Information 
/DOCUMENTATION 
PRE-FORMED 
HANDSET 
HANDSEl 
CORD PACKAGING 
, CONSOLE 
PACKAGING  PRE-FORMED 
7959ROEO 
Figure 5-16 Unpacking Attendant Console 
Page 5-41  

Shipping, Receiving, And Installation Information 
DPABX 
CROSS 
%ECT 
MODULAR 
JACK 
25 PAIR 
CONNECTORIZED 
CABLE x 
QUAD 
STATION 
WIRE 
CONSOLE 
MODULAR 
CORD 
CONSOLE MODULE 
NOTE: 
USE ONLY MITEL CABLE 
ON UNIVERSAL 
P/N 559900007 FOR THE 
CARD 
CONSOLE MODULAR CORD. 
7706RlE2 
Figure 5-l 7 Console Installation 
Page 5-42  

Shipping, Receiving, And Installation information 
Step Action 
1. 
2. 
3. 
4. CHART 5-19 
INSTALL UNIVERSAL CARD AND MODULES 
While wearing the antistatic wrist strap, Figure 5-18 shows a Universal C 
unpack the universal card(s) and its modules. and Modules. 
Inspect for loose or missing components, 
and for damage. Complete repair tag, repack, and 
return any damaged or incorrect 
items. 
Insert the modules into their assigned 
locations, press them until they snap into 
their standoffs and then...

Shipping, Receiving, And Installation Information 
TABLE 5-5 
MODULE POWER RATING 
Module Power Rating 
Console 5 
Receiver/Relay 2 
MOH/Pager 1 
E&M Trunk 3 
TABLE 5-5 
CONSOLE MODULAR JACK CONNECTIONS 
Jack Pin Pair 
Colour Description 
3 green T2 - line in 
4 red R2 - line in 
1 blue not used 
6 white not used 
Refer to Figure 5-20. 
TABLE 5-7 
E&M TRUNK MODULE SWITCH SETTINGS 
Switches 
Function 12345578 
PABX to Line Gain 
3 dB oxxxxxxx 
-13 dB 1 xxxxxxx 
Line to PABX Gain 
-4 dB xoxxxxxx 
-11 dB...