Lexmark W820n User Manual

99
25
Clearing staple jams
To clear the staple jam so you can continue printing and stapling:
1Open the finisher door (Door K).
2Push down the lever on the stapler.
The staple cartridge holder is released.
Downloaded From ManualsPrinter.com Manuals 

100
3Pull the staple cartridge holder up slightly, and then straight out.
4While holding the staple cartridge holder by the ribbed area, firmly push the small tab up.
The staples are exposed.
5Pull the sheet of jammed staples out and discard them.
6Push the tab down.
Ta b
Ribbed
area
Sheet of
staples
Ta b
Downloaded From ManualsPrinter.com Manuals 

101
7Lift the cartridge holder up slightly to clear the edge of the cartridge housing and slide the
cartridge holder into its housing until it
snapsinto place.
Note:When the cartridge holder is correctly placed, the lever on the stapler moves to its
original position.
8Close the finisher door (Door K).
Edge of
cartridge
housing
Downloaded From ManualsPrinter.com Manuals 

102
26
Ordering supplies and maintenance
items
Note:In the U.S. or Canada, call 1-800-438-2468 for information about Lexmark
Authorized Supplies Dealers in your area. In other countries, contact the place
where you bought your printer.
You can also visit the Lexmark online store atwww.lexmark.comto order supplies.
Ordering a maintenance kit
80 Scheduled Maintenanceappears on the display after 300,000 letter-size pages have printed to
let you know it is time to replace the items in the maintenance kit:...

103
27
Replacing the print cartridge
When the88 Toner Lowmessage appears, you should order a new print cartridge. You can continue
to print after the88 Toner Lowmessage appears for a few hundred pages until the print fades or no
longer prints satisfactorily.
IfToner Alarmis set to Single or Continuous, press
Goto continue printing.
WARNING:We do not recommend refilling used print cartridges or purchasing refilled
cartridges from a third party. Print quality and printer reliability cannot be
guaranteed if...

104
4Pull up on the handle to open the printer side door (Door A). Gently lower the door to the open
position.
5Using the handholds located on each side, pull open the printer front door (Door F).
Note:You must open the printer side door since the print cartridge cannot be removed
with just the printer front door opened.
6Pull up on the latch to release and slide the print cartridge out until you see the handle.
Door F
Handhold
Handle
Latch
Downloaded From ManualsPrinter.com Manuals 

105
7Use the handle to pull the print cartridge straight out.
8Set the print cartridge aside.
9Clean the printer. SeeCleaning the printer.
Installing the new print cartridge
1Remove the new cartridge from the plastic bag. Save the bag.
2Remove the tape and protective paper from the top of the print cartridge.
Protective
paper
Ta p e
Downloaded From ManualsPrinter.com Manuals 

106
3Shake the print cartridge back and forth vigorously.
4Use the handle to hold the print cartridge and slide the print cartridge halfway in.
Downloaded From ManualsPrinter.com Manuals 

107
5Drop the handle back into place.
6Push the print cartridge into the printer until the car tridge clicks into place.
7Remove the tape from the end of the cartridge.
8Close the printer side door (Door A).
9Close the duplex unit door (Door E).
Downloaded From ManualsPrinter.com Manuals 

108
10Hold both sides of the printer front door (Door F) and close it.
11Turn the printer on.
12Place the used print cartridge in the plastic bag you saved instep 1 on page 105.
13Follow the instructions on the new print cartridge box to recycle the used print cartridge.
Downloaded From ManualsPrinter.com Manuals