Lexmark W820n User Manual

149
46
Removing the optional mailbox
To remove an optional mailbox and its stand, complete the following sections.
Preparing for disassembly
1Turn the printer off.
2Remove all print media from all the bins.
Disconnecting the power cords
1Unplug the printer power cord from the electrical outlet.
2Unplug the other end of the cord from the printer. Set the cord aside.
Downloaded From ManualsPrinter.com Manuals 

150
3Disconnect the mailbox cable from the back of the printer.
Using the handling tool
The handling tool is located at the back of the printer and mailbox. It rests in a cutout area tooled into
the mailbox cover and attaches to the stand for the mailbox for safekeeping while not in use. The tool
is used for lifting the mailbox off the printer.
1Locate the handling tool at the back of the mailbox. Press the button to the left of the tool to
release it from the stand.
Downloaded From ManualsPrinter.com...

151
2Lift the handling tool up and pull it toward you.
3Open the mailbox door (Door D).
4Locate the area in the mailbox with two round metal tabs.
5Hold the handle of the tool as shown and align the two larger openings on the tool with the two
round metal tabs.
Downloaded From ManualsPrinter.com Manuals 

152
6Slide the tool onto the tabs.
7Lift up slightly on the handle. The plastic tab near the metal tabssnapsinto place in the small
opening on the tool.
Large openingsMetal tabs
Downloaded From ManualsPrinter.com Manuals 

153
Removing the mailbox from the printer and stand
1Locate the latch on the horizontal bar.
2Pullforwardonthetabuntilitclicksinto place.
CAUTION:The mailbox is heavy, and requires two people to lift it.
Latch Ta b
Horizontal bar
Downloaded From ManualsPrinter.com Manuals 

154
3Have someone help you lift the mailbox straight up off of the printer.
Use the handling tool and the horizontal bar to grasp the mailbox.
WARNING:Set the mailbox aside by resting the door of the mailbox on a flat surface;
otherwise, you would damage the mailbox plastic deflector under the bins.
Horizontal bar
Handling tool
Downloaded From ManualsPrinter.com Manuals 

155
Removing the mailbox stand
Two people are required to remove the upper portion of the mailbox stand.
1Locate the tab on each side of the stand.
2Push in on the tabs and lift the upper portion of the stand straight up.
3Set the upper portion of the stand aside.
4Remove the thumbscrews on the right and left side stand pieces. Save the thumbscrews.
Right side stand
piece (back view
of printer)
Downloaded From ManualsPrinter.com Manuals 

156
5Lift up on the right side stand piece, and then pull it off of the printer.
6Set the right side stand piece aside.
7Remove the screw on the stabilizer bar.
(Back view of printer)
Downloaded From ManualsPrinter.com Manuals 

157
8Slide the piece attached to the printer to the back until it falls off the printer.
9Lift the left side stand piece up, and then pull it off of the printer.
10Set the left side stand piece aside.
11At the back of the printer, locate the stabilizer foot under the high capacity feeder or printer
stand.
Downloaded From ManualsPrinter.com Manuals 

158
12Pull the metal pin out of the stabilizer foot. Set it aside.
13Slide the stabilizer foot toward you.
14Reattach the stacking arm. SeeReinstalling the stacking armfor more information.
15Plug in the printer power cord.
16Turn the printer on.
Downloaded From ManualsPrinter.com Manuals