Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

SUNROOF
76-6-2 ADJUSTMENT 

SUNROOF
REPAIRS 76-6-3
REPAIRS
Sunroof 
$% 76.84.01 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
WARNING: It is imperative that before any work 
is undertaken on the SRS system, the 
appropriate information is read thoroughly.
Remove
1.Make the SRS system safe. 
 
 +  GENERAL INFORMATION, 
Supplementary Restraint System (SRS) 
Precautions.
WARNING: Always disconnect both battery...

SUNROOF
76-6-4 REPAIRS
Refit
1.Clean sun roof and mating face.
2.With assistance, fit sun roof and tighten bolts 
evenly to 10 Nm (7 lbf.ft).
3.Tighten Allen screw to 6 Nm (4.4 lbf.ft).
4.Connect multiplug to motor.
5.Position and secure rear console harness.
6.Ensure drain tubes are clear.
7.Connect drain tubes to sun roof.
8.Fit headlining.
 
 +  INTERIOR FITTINGS, REPAIRS, 
Headlining.
9.Connect battery leads, earth lead last.
10.If fitting a new sunroof, the following 
initialisation procedure must...

BODY DIMENSIONS
BODY DIMENSIONS -1
BODY DIMENSIONS BODY DIMENSIONS
Dimensional Information
Measurement Types
The following dimensional information is shown so as to assist the technician in the diagnosis and repair of body 
panels. The information is shown in two different styles. There are X,Y,Z dimensions and actual point to point 
dimensions.
The X,Y,Z dimensions are the measuring planes used within Land Rover for the measurement of body panels. The 
whole bodyshell is within a parallel grid system....

BODY DIMENSIONS
-2 BODY DIMENSIONS
Dimensional Illustrations
X,Y,Z Dimensional Information
Front end dimensional information
Item Description X Y Z
A Tooling hole - front armature mounting 
bracket-707.8 (-27.866) 578.5 (22.775) 241 (9.488)
B Valance outer - headlamp mounting 
panel lower fixing hole-580 (-22.834) 817.1 (32.169) 693.7 (11.255)
C Outboard fixing hole - damper mounting 4.2 (0.165) 649.6 (25.574) 755 (29.724)
D Large hole - damper mounting 3.2 (0.126) 586.3 (23.082) 750 (29.527)
E Tooling...

BODY DIMENSIONS
BODY DIMENSIONS -3
Underbody dimensional information 
Item Description X Y Z
A Front sub-frame - front fixing hole -322 (-12.677) 419 (16.496) 175 (6.889)
B Front sub-frame - middle fixing hole 20 (0.787) 425 (16.732) 175 (6.889)
C Front sub-frame - rear fixing hole 434 (17.086) 435.5 (17.145) -65 (-2.559)
D Cross member - front fixing hole 774.2 (30.48) 340.4 (13.4) LH, 
277.6 (10.929) RH92.9 (3.657)
E Main floor - tooling hole 1021.2 (40.204) 337.6 (13.291) 91.7 (3.61)
F Cross member -...

BODY DIMENSIONS
-4 BODY DIMENSIONS
Side dimensional information
Item Description X Y Z
A Front door top hinge - top fixing hole 623.5 (24.547) 841.4 (33.125) 757.7 (29.83)
B Front door bottom hinge - top fixing 
hole602.4 (23.716) 849.5 (33.444) 293.1 (11.539)
C Front door striker - bottom fixing hole 1669.1 (65.712) 843.3 (33.2) 549.1 (21.618)
D Rear door top hinge - top fixing hole 1766.2 (69.535) 857.7 (33.767)  731.7 (28.807)
E Rear door bottom hinge - top fixing 
hole1734.6 (68.291) 866.7 (34.122)...

BODY DIMENSIONS
BODY DIMENSIONS -5
Rear end dimensional information
Item Description X Y Z
A Tail gate upper - inboard hinge fixing 
hole3253.1 (128.074) 473.4 (18.637) 1380.2 (54.338)
B Tailgate upper - gas strut fixing hole 3351.8 (131.96) 570.5 (22.46) 1302.6 (51.283)
C E post drain channel - finisher fixing 
hole3661.2 (144.141) 663.3 (26.114) 943.4 (37.141)
D Tailgate lower, hinge - lower fixing 
hole3717.2 (146.346) 283.5 (11.161) LH, 
377.5 (14.862) RH336 (13.228)
E Rear armature - outboard top...

BODY DIMENSIONS
-6 BODY DIMENSIONS
Front end, point to point dimensional information
Item From To Length
A Valance outer, bulkhead lower fixing 
hole, LHValance outer, bulkhead lower fixing hole, 
RH1634.2 (64.338)
B Front armature mounting plate, tooling 
hole, LH Front armature mounting plate, tooling 
hole, RH 861 (33.897)
C Damper mounting, outboard fixing, LH Damper mounting, outboard fixing, RH 1172.6 (46.165)
D Windscreen side finisher, lower fixing 
hole, LHWindscreen side finisher, lower fixing...

BODY DIMENSIONS
BODY DIMENSIONS -7
Body side, point to point dimensional information
Item From To Length
A Body side, top hinge fixing hole - front 
doorBody side, bottom hinge fixing hole - rear 
door1172.7 (46.169)
B Body side, bottom hinge fixing hole - 
front doorBody side, top hinge fixing hole - rear door 1243.7 (48.964)
C Body side, top hinge fixing hole - rear 
doorBody side, top striker fixing hole - rear door 827.4  (32.574)