Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

BRAKES
70-14 REPAIRS
Cable - handbrake 
$% 70.35.25
Remove
1.Position vehicle on lift.
2.Remove brake disc.
 
 +  BRAKES, REPAIRS, Brake disc - 
rear.
3.Remove brake shoe upper return spring.
4.Rotate brake shoe retainers 90 ° and remove.
5.Remove lower return spring and adjuster from 
brake shoes.6.Remove shoe expander.
7.Remove rear propeller shaft.
 
 +  DRIVESHAFTS, REPAIRS, Propeller 
shaft - rear.
8.Remove centre console.
 
 +  INTERIOR FITTINGS, REPAIRS, 
Centre console.
9.Remove cable clip and...

BRAKES
REPAIRS 70-15
11.Remove bolt securing handbrake cable to 
backplate.
12.Release cable from chassis clip.
13.Remove bolt securing cable retaining clip to 
sub-frame.
NOTE: Do not carry out further dismantling if 
component is removed for access only.
14.Remove cable mounting bracket from 
handbrake cable.
Refit
1.Fit support bracket to cable.
2.Clean expander.
3.Position handbrake cable and secure to 
expander.
4.Fit and secure handbrake cable to backplate, 
tighten bolt to 8 Nm (6 lbf.ft)....

BRAKES
70-16 REPAIRS
Switch - handbrake warning 
$% 70.35.40
Remove
1.Remove centre console.
 
 +  INTERIOR FITTINGS, REPAIRS, 
Centre console.
2.Remove screw securing switch.
3.Release lead from switch.
4.Remove switch.
Refit
1.Connect lead and position switch to handbrake 
lever, ensuring lug on handbrake lever locates 
in hole in switch. Fit and tighten screw.
2.Fit centre console.
 
 +  INTERIOR FITTINGS, REPAIRS, 
Centre console.
Pads - front  
$% 70.40.02 
WARNING: Brake pads must be renewed in...

BRAKES
REPAIRS 70-17
8.Remove brake pads from caliper housing, mark 
their fitted position if they are to be refitted.
9.Repeat procedure for other side.
Refit
1.Clean caliper housing and caliper carrier using 
brake cleaning fluid.
WARNING: Do not use compressed air to 
clean brake components. Dust from friction 
materials can be harmful if inhaled.
2.Clean brake pad, caliper housing and carrier 
contact areas and apply suitable anti-seize 
compound.
3.Inspect caliper and seals for damage.
4.Position...

BRAKES
70-18 REPAIRS
Pads - rear  
$% 70.40.03 
WARNING: Brake pads must be renewed in axle 
sets only, otherwise braking efficiency may be 
impaired. If pad wear warning light has been 
activated,  pad wear sensor must be renewed.
Remove
1.Raise rear of vehicle.
WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.
2.Remove road wheels.
3. RH side only:  Release pad wear sensor.
4.Remove anti-rattle spring from caliper housing.
5.Remove 2...

BRAKES
REPAIRS 70-19
Sensor - pad wear - front 
$% 70.40.04
Remove
1.Raise front of vehicle, one side.
WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.
2.Remove LH front road wheel.
3.Open cover on multiplug housing, release and 
disconnect pad wear sensor multiplug.
4.Release sensor lead from body bracket, clip, 
brake hose bracket and bleed screw dust cap.
5.Disconnect pad wear sensor from brake pad.
6.Remove sensor.Refit
1.Fit sensor...

BRAKES
70-20 REPAIRS
Sensor - pad wear - rear 
$% 70.40.05
Remove
1.Raise rear of vehicle, one side.
WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.
2.Remove RH road wheel.
3.Remove 5 screws securing wheel arch liner 
and release liner for access to multiplug 
housing.
4.Open cover on multiplug housing, release and 
disconnect pad wear sensor multiplug then 
release sensor lead from spring turret, 
suspension arm and bleed screw dust...

BRAKES
REPAIRS 70-21
Shoes - rear set  
$% 70.40.09
Remove
1.Raise rear of vehicle.
WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.
2.Remove road wheels.
3.Remove brake disc.
 
 +  BRAKES, REPAIRS, Brake disc - 
rear.
4.Remove brake shoe upper return spring.
5.Rotate brake shoe retainers 90 ° and remove.
6.Remove brake shoe assembly complete with 
lower spring and adjuster.
7.Remove lower return spring and adjuster from 
brake...

BRAKES
70-22 REPAIRS
Servo assembly 
$% 70.50.01
Remove
1.Remove engine compartment bulkhead closing 
panel.
2.Remove brake master cylinder.
 
 +  BRAKES, REPAIRS, Cylinder - 
master - tandem.
3.Disconnect vacuum pipe from servo.
4.Remove nut securing alarm sounder to 
mounting bracket and move aside.
5.Remove bolt securing pre-charge pump 
bracket to body.
6.Release pump from rubber mounting.
7.Disconnect multiplug.
8.Remove pump.
9.Remove shroud.
 
 +  INTERIOR FITTINGS, REPAIRS, 
Shroud - lower -...

BRAKES
REPAIRS 70-23
Vacuum pump - Td6
$% 70.50.19 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Disconnect battery earth lead.
2.Remove engine access cover.
 
 +  ENGINE - Td6, REPAIRS, Cover - 
engine access.
3.Release clip and disconnect hose from vacuum 
pump.
4.Remove and discard 2 bolts securing vacuum 
pump.
5.Remove vacuum pump and discard O ring.
Refit
1.Clean...