Home
>
Land Rover
>
Automobile
>
Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual
Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual
Here you can view all the pages of manual Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual. The Land Rover manuals for Automobile are available online for free. You can easily download all the documents as PDF.
Page 111
TORQUE WRENCH SETTINGS 06-22 Heating and Ventilation Air Conditioning Wipers and Washers TORQUE DESCRIPTION METRIC IMPERIAL Plenum assembly nuts 10 Nm 7 lbf.ft Positive cable to stud nut 20 Nm 15 lbf.ft Heater pipe securing bolts 10 Nm 7 lbf.ft Fuel burning heater mounting bracket bolts 10 Nm 7 lbf.ft Fuse box bolts 6 Nm 4.4 lbf.ft TORQUE DESCRIPTION METRIC IMPERIAL Compressor drive belt tensioner bolts 25 Nm 18 lbf.ft A/C pipes to compressor bolts 22 Nm 16 lbf.ft A/C compressor mounting bolts 25 Nm...
Page 112
TORQUE WRENCH SETTINGS 06-23 Electrical + New nut must be fitted TORQUE DESCRIPTION METRIC IMPERIAL Jockey pulley carrier bracket bolts to alternator 45 Nm 33 lbf.ft Battery cable to alternator nut 13 Nm 10 lbf.ft Upper ancillary drive belt jockey pulley bolt 25 Nm 18 lbf.ft Alternator to casing bolts 13 Nm 10 lbf.ft Ancillary belt tensioner block bolts - Td6 25 Nm 18 lbf.ft Ancillary drive belt tensioner to timing cover nut - Td6 + 10 Nm 7 lbf.ft Idler pulley to mounting Allen bolt - Td6 25 Nm 18...
Page 114
LIFTING AND TOWING 08-1 LIFTING AND TOWING Lifting The following instructions must be carried out before raising the vehicle off the ground. lUse a solid level ground surface. lApply hand brake. lSelect P on automatic gearbox selector. To avoid damage occurring to the under body components of the vehicle the following jacking procedures must be adhered to. DO NOT POSITION JACKS OR AXLE STANDS UNDER THE FOLLOWING COMPONENTS: lBody structure other than approved jacking points lBumpers lFuel lines...
Page 115
LIFTING AND TOWING 08-2 Reverse procedure when removing vehicle from stands. Raising the rear of the vehicle Select P on automatic gearbox selector and chock front wheels. WARNING: Always chock the front wheels when jacking the rear of the vehicle. Position cup of hydraulic arm under the centre of the rear sub-frame, rear cross member, as shown in illustration above. The vehicle may also be lifted using the centre of the tow bar, if fitted. Axle stand positions - rear Raise rear of vehicle to...
Page 116
LIFTING AND TOWING 08-3 Wheel-free lift The following warning must be read before attempting to lift the vehicle. WARNING: The vehicle cannot be supported safely in a wheel-free condition using the wheel- free facility of a four post ramp, and under no circumstances must this method be employed. A wheel free condition may only be achieved on a four post ramp by raising each end of the vehicle and positioning axle stands beneath the recommended customer jacking points. CAUTION: Place a piece of...
Page 117
LIFTING AND TOWING 08-4 Towing Towing The vehicle has permanent four wheel drive. The following towing instructions must be adhered to: Towing on 4 wheels with driver operating steering and brakes Select N on automatic gearbox selector. CAUTION: If N cannot be selected, vehicle must not be towed. Set the transfer box in neutral by inserting a spare 5 amp fuse in position 37 in passenger compartment front fusebox. CAUTION: If, due to an electrical fault, neutral cannot be selected due to battery...
Page 118
LIFTING AND TOWING 08-5 Towing/lashing eyes The single towing/lashing eyes at the front and rear of the vehicle are designed for vehicle recovery purposes only and must NOT be used to tow a trailer or caravan. Transporting Transporting by trailer Lashing eyes are provided at the front and at rear of the vehicle.DO NOT secure lashing hooks or trailer fixings to any other part of the vehicle. Position the vehicle on the trailer and apply the handbrake. Select N on the automatic gearbox selector....
Page 120
CAPACITIES, FLUIDS, LUBRICANTS AND SEALANTS 09-1 CAPACITIES, FLUIDS, LUBRICANTS AND SEALANTS Capacities The following capacities are only an approximation of the amount of fluid required to fill the respective system. Capacities - UK EURO ROWCapacities - NAS Refrigerant - A/C system Component Metric Units Fuel tank 98 litres Engine - Td6: ⇒ Engine oil and filter change 8.75 litres ⇒ Fill from dry 9.5 litres Engine - V8: ⇒ Engine oil and filter change 8.5 litres ⇒ Fill from dry 9.1 litres GM Automatic...