Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

GENERAL DATA
04-6
Valves 
Valve head diameter:
⇒ Inlet
⇒ Exhaust35.0 mm (1.411 in)
30.5 mm (1.200 in)
Stem diameter - Inlet valves:
⇒ Standard
⇒ Service limit
⇒ 1st oversize
⇒ Service limit
⇒ 2nd oversize
⇒ Service limit
⇒ Exhaust valves
⇒ Standard
⇒ Service limit
⇒ 1st oversize
⇒ Service limit
⇒ 2nd oversize
⇒ Service limit6.0 mm (0.24 in)
5.96 mm (0.234 in)
6.1 mm (0.240 in)
6.06 mm (0.238 in)
6.2 mm (0.244 in)
6.16 mm (0.242 in)
6.0 mm (0.24 in)
5.94 mm (0.23 in)
6.1 mm (0.240 in)
6.04 mm (0.237 in)...

GENERAL DATA
04-7
Big-end bearings
Diametrical clearance 0.020 to 0.056 mm (0.0007 to 0.0022 in)
Diameter - Standard
⇒ Service limit
⇒ 1st oversize
⇒ Service limit
⇒ 2nd oversize
⇒ Service limit
⇒ 3rd oversize
⇒ Service limit48.00 mm (1.891 in)
47.97 mm (1.888 in)
47.75 mm (1.879 in)
47.72 mm (1.878 in)
47.50 mm (1.870 in)
47.47 mm (1.860 in)
47.25 mm (1.860 in)
47.25 mm (1.850 in)
Pistons and piston rings
Piston running clearance in cylinder bore: 0.006 to 0.038 mm (0.0002 to 0.0015 in)
Piston to...

GENERAL DATA
04-8
Fuel system - Td6
Fuel system - V8
Type Common rail injection with high and low pressure systems
High pressure pump Chain driven from engine.
High pressure pump delivery pressure:
⇒ Low pressure 1.5 to 5.0 bar (21.75 to 72.5 lbf.in
2)
⇒ High pressure 200 to 1350 bar (2900 to 19575 lbf.in
2)
Advance delivery pump Electric, located in fuel tank
Secondary fuel pump In-line, electric, positioned on side of fuel tank
Fuel rail pressure sensor Inserted in end of fuel rail
Injectors Electronic...

GENERAL DATA
04-9
Cooling system - Td6
Cooling system - V8
Type Pressurised, thermostatically controlled with remote header tank
Cooling fans  Viscous coupled and axial flow electric
Coolant pump Centrifugal impeller, belt driven from crankshaft 
Thermostat Waxstat 
Thermostat opening temperature 85 °C (185 °F)
Type Pressurised, thermostatically controlled with remote header tank 
Cooling fans Viscous coupled and axial flow electric
Coolant pump Centrifugal impeller, belt driven from crankshaft...

GENERAL DATA
04-10
Transfer box 
Make/Type New Venture Gears - NV225 - two speed reduction on main gearbox 
output. Front and rear drive permanently engaged by means of a 
Torsen differential. High/low selection by means of an electronic 
stepper motor
Ratios:
⇒ High range 1.00 : 1
⇒ Low range 2.694 : 1 

GENERAL DATA
04-11
Automatic gearbox - Td6 engine
Automatic gearbox - V8 engine
Make/Type General Motors GM5 automatic, type 5L40-E, 5 speed with Steptronic 
control and sport mode
Gears 5 forward, 1 reverse
Gear ratios:
⇒ First 3.42:1
⇒ Second 2.21:1
⇒ Third 1.60:1
⇒ Fourth 1.00:1
⇒ Fifth 0.75:1
⇒ Reverse 3.03:1
Shift speeds:
⇒ Low to high
⇒ High to low30 kph (48 mph)
10 kph (16 mph)
Road speed @ 1000 rev/min:
⇒ 5th - High
⇒ 1st - High
⇒ 1st - Low44.76 kph (27.8 mph)
9.86 kph (6.1 mph)
3.66 kph (2.3...

GENERAL DATA
04-12
Propeller and drive shafts
Front differential
Rear differential
Propeller shafts - type Front - 50 mm (1.9 in) diameter - nominal with sliding joint and SGF 
coupling
Rear - 60 mm (2.4 in) diameter - nominal with constant velocity joints, 
flexible coupling and intermediate support bearing
Drive shafts - type Front - Variable length incorporating constant velocity joints at each end of 
shaft
Rear - Fixed length incorporating constant velocity joints at each end of 
shaft
Type Hypoid...

GENERAL DATA
04-13
Steering
Type Speed proportional
Steering wheel turns lock to lock 3.5
Steering wheel diameter 400 mm (15.7 in)
Turning circle, kerb to kerb 11.6 metres (38.0 feet)
PAS pump:
Td6 Model
V8 ModelZF FP4
ZF FP6
PAS pump pressure: 
At idle
At full lock8 bar (116 lbf/in
2)
133 bar (1928.5 lbf/in2) - Maximum
Steering geometry:
Camber angle at standard height:
⇒ Front
⇒ Rear
Maximum difference - Right to Left hand - Front and rear-20 ± 30
-1° ± 30
30
King pin inclination 11° 46
⇒ Castor angle...

GENERAL DATA
04-14
Front and rear suspension
* Measurement taken with vehicle at unladen weight and suspension in on road setting.
Type - Front Independent, Macpherson struts with air springs, gas tube dampers, 
height sensors and anti-roll bar
Type - Rear Independent with air springs, gas tube dampers, height sensors and 
anti-roll bar
Nominal height from hub centre to wheel arch (not 
liner):*
⇒ Front
⇒ Rear493 ± 2 mm (19.4 in ± 0.08 in)
483 ± 2 mm (19.0 in ± 0.08 in) 

GENERAL DATA
04-15
Brakes
Type Servo assisted, self-adjusting with front/rear split hydraulic system, pin 
sliding calipers and dynamic stability control
Disc type and diameter:
⇒ Front - ventilated
⇒ Rear - solid344 mm (13.5 in)
354 mm (13.9 in)
Front disc thickness:
⇒ New
⇒ Service limit
⇒ Thickness variation30.0 mm (1.18 in)
28.4 mm (1.12 in)
0.010 mm (0.0004 in)
Rear disc thickness:
⇒ New
⇒ service limit
⇒ Thickness variation12.0 mm (0.47 in)
10.4 mm (0.41 in)
0.010 mm (0.0004 in)
Maximum disc...