Konica Minolta bizhub C35 User Manual

Replacing Consumables 11-28
16Install the all toner cartridges, all 
imaging units and waste toner 
bottle.
For details on installing 
the toner cartridges, 
imaging units or waste 
toner bottle, refer to 
“Replacing a Toner Car-
tridge” on page 11-4 or 
“Replacing a Imaging 
Unit” on page 11-9.
17Close the front cover.
When closing the front 
cover, press the area of 
the cover with small pro-
jections.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-29
18Reconnect the power cord, and 
turn on the machine.
19Reset the counter in the [Admin Settings]/[Maintenance Menu]/[Supplies]/
[Consumables Replace]/[Transfer Belt Unit] menu.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-30
Replacing the Backup Battery
When the backup battery is at its end of life, the machine’s date and time can-
not be retained. Follow the procedure described below to replace the backup 
battery.
Note
Only use the coin-shaped 3V lithium battery CR2032. It’s very important 
to protect the machine controller board and any associated circuit 
boards from electrostatic damage. Before performing this procedure, 
review the antistatic caution on page 11-38. In addition, always handle...

Replacing Consumables11-31
3Using a coin, remove a screw.
4Open the cover.
5Remove the hook, and then 
remove the backup battery.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-32
6Remove the hook, and then 
insert a new backup battery.
When inserting the new 
backup battery, be sure 
that the + side faces tow-
erd the left.
Risk of explosion if bat-
tery is replaced by an 
incorrect type. Dispose of 
used batteries according 
to your local regulations. 
Do not burn the backup 
battery.
7Reinstall the panel and tighten a screw.
8Install the cover.
9Reconnect all interface cables.
10Reconnect the power cord, and 
turn on the machine.
11Use [Date(XX....

Replacing Consumables11-33 Replacing the Fuser Unit
When the time to replace the fuser unit is reached, the message [Replace 
fusing unit.] appears. Printing can continue even after this message appears; 
however, since the print quality is reduced, the fuser unit should be replaced 
immediately
1Turn off the machine.
Note
There are extremely hot parts within the machine. Before replacing the 
fuser unit, wait about 20 minutes after turning off the machine, and then 
check that the fusing section has...

Replacing Consumables 11-34
4Pull down the 2 levers. 
5Remove the fuser unit.
6Prepare a new fuser unit.
Be careful not to touch the 
surface of the fuser roller.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-35
7Lift up the 2 levers.
8Remove the packing material.
9Push down the 2 levers.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-36
10Pull down the 2 levers of a new 
fuser unit.
11Insert the fuser unit until it locks 
into place.
12Lift up the 2 levers.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-37
13Close the fuser unit cover.
14Close the right door.
If the door cannot be closed, 
check that the fuser unit is 
fully inserted.
15Reset the counter in the [Admin Settings]/[Maintenance Menu]/[Supplies]/
[Consumables Replace]/[Fusing Unit] menu.
Downloaded From ManualsPrinter.com Manuals