Konica Minolta bizhub C35 User Manual

Replacing Consumables 11-8
11Close the front cover.
When closing the front 
cover, press the area of 
the cover with small pro-
jections.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-9 Replacing a Imaging Unit
Note
Do not touch the OPC drum 
surface. This could lower image 
quality.
If the messages [Replace Imaging Unit] appear, replace the specified imaging 
unit. As an example, the procedure for replacing the black imaging unit is 
described below.
1Check the message window to see which color imaging unit needs replac-
ing.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-10
2Open the machine’s front cover.
3Pull the front lever of the color 
toner cartridge indicated to the 
left.
The replacement procedure for 
the imaging unit is the same for 
all colors (yellow: Y, magenta: M, 
cyan: C, and black: K).
The following instructions show 
the procedure to replace the 
toner cartridge (K).
YMCK
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-11
4Grab the handle of the toner car-
tridge to be removed, and then 
pull out the cartridge.
Do not tilt removed toner car-
tridge, otherwise toner may 
spill.
5Pull up the waste toner bottle to 
unlock it.
6Grab the left and right handles of 
the waste toner bottle, and then 
slowly pull out the bottle.
Do not tilt removed waste 
toner box, otherwise 
waste toner may spill.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-12
7While pressing down the area 
marked “Push” on the imaging 
unit to be replaced, slide the unit 
completely out of the machine. 
The following instructions show 
the procedure to replace the 
imaging unit (K).
Note
Dispose of the used imaging unit according to your local regulations.
Do not burn the imaging unit.
8Check the color of the new imaging unit to be installed.
In order to prevent toner from spilling, leave the imaging unit in the 
bag until step 7 is being...

Replacing Consumables11-13
10Hold the imaging unit with both 
hands, and then shake it twice 
as shown in the illustration.
Do not grab the bottom of 
the bag; otherwise, the 
imaging unit may be 
damaged, resulting in 
decreased print quality.
11Remove the protective cover 
from the imaging unit.
Remove all packing tape from 
the imaging unit
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-14
12Remove the paper from the 
imaging unit. 
Remove the protective cover 
from the imaging unit.
13Make sure that the new imaging 
unit to be installed is the same 
color as the machine compart-
ment, and then install the imag-
ing unit in the machine.
14Press in on the waste toner bot-
tle until it locks into place.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-15
15Make sure that the toner car-
tridge is the same color as the 
machine compartment, and then 
insert the toner cartridge into the 
machine.
Fully insert the toner car-
tridge.
16Pull the lever to the right to lock 
it in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the machine cannot be 
closed.
If it is difficult to operate 
the lever, push it in.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 11-16
17Close the front cover.
When closing the front 
cover, press the area of 
the cover with small pro-
jections.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables11-17 Replacing the Waste Toner Bottle
When the waste toner bottle becomes full, the message [Waste Toner Box 
Full] appears in the message window. The machine stops and will not start 
again until the waste toner bottle is replaced.
1Open the machine’s front cover.
2Pull up the waste toner bottle to 
unlock it.
Downloaded From ManualsPrinter.com Manuals