Home > JVC > Receiver > JVC R S11 Manual

JVC R S11 Manual

    Download as PDF Print this page Share this page

    Have a look at the manual JVC R S11 Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 313 JVC manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							3
    A  Typical connections / JèY
    ŸÞÙ,
    Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious 
    damage to this unit.
    The leads of the power cord and those of the connector from the car body may be different in color.
    1  Connect the colored leads of the power cord in the order specified in the illustration below.
    2  Connect the antenna cord.
    3  Finally connect the wiring harness to the unit.
    Line out (see diagram  )
    ÞÌi€
    a¡Œ  Rear ground terminal
    IÚà
    ٨L
    15 A fuse
    15 A­ˆ
    
    Black
    
    ½
    Blue with white stripe
    
    mÞc
    â	m Red
    Î
    Yellow 
    *2
    
    »
     *2
    To metallic body or chassis of the car
    
    Ÿ–nÐÛµµIgnition switch
    Ãæ
    šë
    Fuse block
    ­ˆ
    
    ©
    To an accessory terminal in the fuse block
    
    Left speaker (front)
    Right speaker (front)
    Left speaker (rear)
    Right speaker (rear)
     Purple
    
    
     Purple with black stripe
    
    
    mÞ
    ½
    â	m Green
    `
     Green with black stripe
    `
    mÞ
    ½
    â	m  Gray
    ò
     Gray with black stripe
    ò
    mÞ
    ½
    â	m White
    c
     White with black stripe
    c
    mÞ
    ½
    â	mTo a live terminal in the fuse block connecting to the car battery 
    (bypassing the ignition switch) (constant 12 V)
    
    Ÿ­ˆ
    
    ©«Y
    meLd­ˆ
    
    ©~eë´¹
    Ÿ
     12 V
    To the remote lead of other equipment (200 mA max.)
    ¹
    ŸIüÄjYÇ
    ›¬Þ€ð}200 mA
    Orange with white stripe
    Ð
    mÞc
    â	m
    To car light control switch
    ¹
    Ÿñ
    ›S
    šë To external components (see diagram 
     )
    
    Ÿ.
    ŸÄ€
    a¡Œ   Antenna terminal
    ÂÞL
    
    ŸÞÃjúZè_Û«YÞ)f”M½Y
    ŸÞ6¬çIÚ &xf
    
    1 
    2 
    ZÂÞYeÞ¹
    Ÿ	Î8f
    3 ðdª	ãÞ¼Yb˜b¯IÚjf
    Blue
    
    To the automatic antenna if any (250 mA max.)
    250 mA
      ENGLISH  •Ö
    B
    ELECTRICAL CONNECTIONSe)¹
    Ÿ
    *1  Not supplied for this unit.*2  Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power 
    cannot be turned on.*1 ”‡IÚd6f*2 
    Install3-4_KD-BT11[UT]_6.indd   3Install3-4_KD-BT11[UT]_6.indd   312/11/07   13:22:5712/11/07   13:22:57 
    						
    							4
    Set “L/O MODE” to “REAR” (See page 21 of the 
    INSTRUCTIONS.)
    
    Z¨L/O MODE©£›‰¨REAR©€
    a4\­üãY
    K 21 
    Set “L/O MODE” to “SUB.W” (See page 21 of 
    the INSTRUCTIONS.)
    
    Z¨L/O MODE©£›‰¨SUB.W©€
    a4\­üãY
    K 21 
    To the remote lead of other 
    equipment or automatic antenna 
    if any
    ¹
    ŸIüÄjYÇ
    ›¬ÞÐ
    
    Subwoofer
     -*nJœRear speakers
    ÄnJœY-connector (not supplied for this unit)
    Y-
    Front speakers
    ÃÄnJœ
    JVC Amplifier
    JVC ó}œ
    Signal cord (not supplied for this unit)
    
    or / Ð
    JVC Amplifier
    JVC ó}œ
    B  Connecting the external amplifier or subwoofer / ¹
    Ÿ.Åó}œÐ -*nJœ
    You can connect an amplifier to upgrade your car stereo system.
    •  Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it 
    can be controlled through this unit.
    •  Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker 
    leads of this unit unused.
    †ø¹
    Ÿó}œød/Y*¤ûUf
    • Ç
    ›f
    • 
    ZnJœqIÚà
    šdŽ
    Ÿjó}œf
    ZIÚYnJœ
    ŸÞóÄ”\f
    When connecting the external components, refer also to the manuals supplied for the components and 
    adapter.
    CAUTION:  Before connecting the external components, make sure that the unit is turned off.
    You can connect the following JVC components to the CD changer jack.
    JVC component Model name
    CD changer (CD-CH)CH-X1500, etc.
    You can also connect the following components through the various JVC adapters.
    •  Connection cords may need to be purchased separately.
    Component Adapter Model name
    iPod Interface adapter for iPod KS-PD100
    Portable audio player with line input 
    jacksLine input adapter KS-U57
    Portable audio player with 3.5 mm 
    stereo mini jackAUX input adapter KS-U58
    *
    3 Ç
    ›¬Þ*4 
    Z®Þ~–nÐkÛµµa
    W¹
    Ÿd¹
    ŸˆÐÚÞ—0Š€½Š
    éj0d¯¹
    ŸeÞ
    *3  Remote lead*4  Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint 
    (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the 
    unit.
      Connecting the external components / ¹
    ŸIü.
    ŸÄ
      iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
    To disconnect the connector / Ù
    š¹
    Ÿœ
    Hold the connector tightly ( 1 ), then pull it out ( 2 ).
    a2¹
    Ÿœ€12
    CD changer jack / CDl?œbÆ CD-CH / KS-PD100 / 
    KS-U57 / KS-U58
    When connecting an external component / …¹
    Ÿ.
    ŸÄÛ
     iPod J Apple Inc. 
    ƒÐj¹
    Ÿ.
    ŸÄ˜Ãd‹½›IÚŠ¾ëÐf
    
    †ø¹
    Ÿøh JVC Ä CD l?œbÆf
    JVC Ä èî¤H
    CD l?œ€CD-CHCH-X1500 
    
     JVC 7lœ¹
    ŸøhÄf
    • 
    Ä 7lœ èî¤H
    iPod
    iPod ¢&7lœKS-PD100
    
    mÞÞÌi]bÆY©sÌ*–
    góÚÞÌi]7lœKS-U57
    
    mÞ 3.5 mm mJ	Ö+èbÆ
    Y©sÌ*–góÚAUX i]7lœKS-U58
    C
    Remote lead (blue with white stripe)
    
    Install3-4_KD-BT11[U]_4.indd   4Install3-4_KD-BT11[U]_4.indd   411/29/07   10:06:4611/29/07   10:06:46 
    						
    All JVC manuals Comments (0)

    Related Manuals for JVC R S11 Manual