Home > Inter-Tel > Communications System > Inter-Tel Imx/Gmx 416/832 Installation Manual

Inter-Tel Imx/Gmx 416/832 Installation Manual

Here you can view all the pages of manual Inter-Tel Imx/Gmx 416/832 Installation Manual. The Inter-Tel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 221

INTER-TELPRACTICES 
IMX/GMX 416/832 INS’lXLLATION & MAINTENANCE INSTALLATION 
Issue 1. November 1994 
FIGURE 3-75. 
INTER-TJZIJDVK DSWBLF UNIT CONTROL BOARD 
Page 3-137  

Page 222

IN?ULLATION Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
H. SINGLE-LINE SET AND PLAYBACK 
DEVICE INSTALLATION 
Single-Line Sets 
7.57 Single-line sets can be connected to either Sing- 
le-Line Cards (SLCs) or Inward Dialing Cards (IDCs). 
If connected to SLCs, single-line sets must be equipped 
with AC ringers. If connected to IDCs, off-premises 
single-line sets must be equipped with AC ringers, while 
on-premises single-lines sets may be equipped with ei- 
ther...

Page 223

rNTER-TELPRAcTIcES 
IMWGMX 416/832 INSTALLATION & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
(5) To wall mount an FSLS or SLI, refer to the in- 
structions given for wall mounting keysets on 
page 3-120. 
FIGURE 3-76. SLI CONTROL BOARD 
Page 3-139  

Page 224

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSlXLLATION & MAINTENANCE 
FIGURE 3-77. BOmOM OF ESLS 
J 
. . . . . . . ..i. 
Fib m 
. ..$y. 
0 8 
0 @I 0 8 
RING TONE STRAP 
0 8 
Page 3-140  

Page 225

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION 81 -ANCE lNSTALLATlON 
Issue 1, November 1994 
8. SMDRBMDA OUTPUT DEVICE 
INSTALLATION 
8.1 The output device(s) for the Station Message 
Detail Recording (SMDR) and Station Message Detail 
Accounting (SMDA) features must meet the require- 
ments and match the RS-232-C DB9 and/or DB25 pin- 
outs described in SPECllWKl’TONS on page 2-36. The 
cables for the device(s) must not be longer than 50 feet 
(15 meters). 
8.2 To connect an output device to the...

Page 226

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION 81 MAINTENANCE 
10. Fi3LTERNAL MUSIC SOURCE 
INS’IALLATION 
10.1 If desired, up to two external music sources (Port 
1 and Port 2) may be connected to the system. The first 
two pair of wires on the Matrix Card terminal block (see 
Figure 3-2Oon page 3-32) are the inputs for the optional 
external music sources (radio, tape player, etc.). If two 
music sources are connected, keyset users have the op 
tion of having...

Page 227

INmm-TELPRACTICES A%X/GMX 416/832 INS’IYALLATION % MAINTENANCE INSTALLATION Issue 1, November 1994 
11. SETTING UP THE PC 
MOTHERBOARD 
11.1 Prior to shipping the 4161832 System, the PC 
Motherboard is “set up” to work with the accompanying 
hard disk drive. Under normal circumstances, this sys- 
tem configuration setup does not have to be adjusted. 
However, if a new PC Motherboard or hard disk drive is 
installed in the system, the PC Motherboard setup 
should be checked as outlined below. 
NOTICE...

Page 228

IbWMLLATION Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
played on the monitor matches what is shown 
in the box on the box above. 
e. If any of the information is incomec~ use the 
up or down arrow keys to highlight the de- 
sired prompt, then use the PG UP or PG DN 
keys to change the information. 
NOTE. If using a Seagate ST-225 hard disk 
drive, the Hard Disk C prompt should read 
Type 2. If using a Mini-Scribe M&l 8425 
hard disk drive, the prompt should...

Page 229

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
(6) Re-enable the “watchdog” timer by removing 
of the HDLC Card. 
the jumper (short) from the 2-pin system status 
panel connector. (8) Turn ON the AC POWER switches -main first. 
(7) (The system download takes place and the moni- 
Reconnect the 7-pin system status panel cable to 
the 4-pin and 2-pin connectors on the front edge tor eventually displays the Inter-Tel logo and the 
words “416/832...

Page 230

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 lNSTALLA’I’ION & MAINTENANCE 
I 
I 
I 
I 
I 
I 
12. INSTALLING THE SYSTEM 
SOFTWARE 
12.1 The 416f832 System is shipped with the stan- 
dard-size (416~port) system software already installed 
on the hard disk drive. As a back-up, seven floppy disks 
containing the standard-size system software are also 
included. The seven disks are labeled: Installation Disk 
(l), Applications Setup Disk (2), Applications Software 
Disk (3), Call...
Start reading Inter-Tel Imx/Gmx 416/832 Installation Manual

Related Manuals for Inter-Tel Imx/Gmx 416/832 Installation Manual

All Inter-Tel manuals