Inter-Tel Imx/Gmx 416/832 Installation Manual

FEATURES Issue 1, November 1994 INTER-~PRACTICES 
IMWGMX 416/832 INSTALLATION 8z MAINTENANCE 
J. LEAST-COST ROUTING &CR) 
4.63 
LCR is a money-saving feature that allows the 
system to be programmed to select the desired route for 
placing outgoing calls. For example, the system may be 
programmed to always place calls using the leastex- 
pensive route. It can be used for placing outgoing calls 
or transferring calls to outside telephone numbers, but 
cannot be used for forwarding calls to outside...

I 
INTEFGTELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE FEATURE!3 
Issue 1, November 1994 
‘Itansparent LCR 
4.69 Transparent LCR mode is a station option that 
changes what the user hears so that an LCR call sounds 
like an outside call placed using direct trunk group ac- 
cess. With this mode, dial tone is heard when a call key 
or the LCR, OUT, or OUTGOING key is pressed or 
when the feature code is entered. Dial tone stops when 
the user begins dialing. No tones are heard by the user 
while...

FEATURES Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
K. E&MTRUNKS 
NOTE: This feature is available only in the ExrenuU 
plus Tl and E&h! software packages. 
4.74 E&M trunks, also called “tie” lines, are special 
trunks that tie two distant telephone systems together. 
They allow the users of either telephone system trans- 
parent access to the users and resources of the other tele- 
phone system, often for less than what it would cost to 
use normal long...

INTER-TELPRACTICES IMX/GMX 416/832 INSTALLATION & MAINTENANCE FEATURES 
Issue 1, November 1994 
L TlSPANS 
NOTE: This feature is available only in the Exrended 
plus Tl and E&M software packages. 
4.79 The term “Tl” refers to a specific digital method 
of transmitting voice and data; it is the basic 24-channel 
time-division multiplex, pulse code modulation system 
used in the United States. Since each Tl span actually 
consists of 24 individual circuits (or channels) multi- 
plexed together, it is often...

FEATURES INTER-TELPRACTICES 
Issue 1, November 1994 
JMX/GMJL 416/832 INSTALIATION & MAINTENANCE 
FIGURE 4-l. Tl SPAN APPLICATIONS 
416/832-to-CO wltb extend CSU In this application, the TlCa are connected to the central offioe using an extannl CSU. 
A DSX-1 Interface is enabled and the length of the cabling between the 416/832 Sys- 
416/832-to-CO with onboad CSU In this application, the TlCs are connected diiectly to the central office and optional 
on-board CSUs are used. The line buildout is...

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
M. DIRECTINWARDDIALING (DID) 
4Jl3 Direct inward dialing (DID) allows an outside 
party to dial into the system without attendant interven- 
tion. To gain direct access to the system, an outside party 
dials a number that was assigned by the telephone com- 
pany to the DID trunks installed on the 416/832 System. 
The system then provides ring signal to the station, sta- 
tions, or hunt group according to the programmed ring- 
in/answer...

INTER-TELPRACTICES 
IMX/GMX 416/X32 INSTALLATION & MAINTENANCE 
P. DIRECT INWARD SYSTEM ACCESS 
@ISA) 
4.91 DISA is a programmable feature that allows an 
outside party to dial into the system from an external 
IYIMF telephone and then access the following system 
resources: extension numbers for placing calls to sta- 
tions; trunks groups or auto trunks for placing outgoing 
calls; hunt group pilot numbers; and, if equipped, a mo- 
dem extension number for remote system programming 
or report...

INTER-TEJJPRACTICES 
IMX/GMX 416/832 INSTALLATION % MAINTENANCE ImmuREs 
Issue 1, November 1994 
plied warranty that it is invulnerable to unauthorized in- 
trusions. The installer and owner of the system should 
ensure that proper security measures have been taken to 
prevent outside callers from accessing and misusing 
outgoing trunks for unauthorized calls. Also, if the cen- 
tral office does not provide supervision and disconnect 
the call when one party hangs up, it is possible for a 
caller to...

I 
I 
INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
5. STATION INSTRUMENTS 
5.1 To allow system flexibility and cost efficiency, a 
variety of station instruments can be used on the 
416l832 System. They are: 
IMX 416/832 Digital And Analog Station 
Instruments 
0 
0 
0 
0 
0 
0 
0 
0 
0 
0 
0 Standard Digital Keysets - standard and display 
Executive Digital Keysets - display only 
lMX 12/24-Line Keysets -display and standard 
IMX 8-Line Keysets -non-display only 
IMX 8/12/24-Line AIM...

INTKR-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE ImwuREs 
Issue 1, November 1994 
I 
display will show NO SPKRPHN AVAIL STAY OFF 
HOOK. If the user attempts to change to the speaker- 
phone and hangs up during a call when speakerphones 
are unavailable, the user will be forced into a monitor- 
only mode. The user will be able to hear the other party 
but will not be allowed to transmit to them. In this mode, 
the user’s MUTE key will be lit and the display shows 
NO SPKRPHN AVAIL COME OFF...