GE S5 Service Manual

Appendix B, ElectroMagnetic Compatibility
B-5
Document no. M1031517-02
Table 4 Recommended separation distances between portable and mobile RF 
communications equipment and the S/5™ CAM/ CCCM
 (1  For impedance RESP measurement. For invasive pressure measurement in M-series modules 
except M-PRE(S)TN. The invasive pressure measurement compliance level is dependent on the 
transducer used, and only the lower level is guaranteed for all transducers.  
  (2 For BIS measurement in E-BIS/M-BIS, RESP...

 
B-6
Document no.  M1031517-02
For your notes: 

All specifications are subject to change without notice.
CAUTION: U.S. Federal law restricts this device to sale by or on the order of a licensed medical practitioner.
Outside the USA, check local laws for any restriction that may apply.
Document no. M1031518-02
March, 2006
Datex-Ohmeda Inc.
P.O. Box 7550
Madison, WI 53707-7550, USA
Tel: +1 608 221 1551
Fax: +1 608 222 9147
GE Healthcare Finland Oy
Helsinki, Finland
P.O. Box 900
FI-00031 GE, FINLAND
Tel: +358 10 39411
Fax: +358 9 1463310...

Table of contents
i
                                                                                  Document no. M1031518-02
Table of contents
Table of contents i
1 Planned maintenance instructions 1
1.1 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
1.2 Recommended tools  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Datex-Ohmeda S/5 Compact Anesthesia and Compact Critical Care Monitors
ii
Document no. M1031518-02                                                                    
2.2.20 Memory   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
2.2.21 Recorder   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
2.2.22 Network Option  . . . . . . . ....

Planned maintenance instructions
1
                                          Document no. M1031518-02
1 Planned maintenance instructions
1.1 Introduction
These instructions include procedures for planned maintenance (PM) for the Datex-Ohmeda S/5 
Compact Anesthesia Monitor and S/5 Compact Critical Care Monitor. The Planned maintenance 
should be performed once a year.
These instructions include “Planned maintenance check form, S/5 Compact Monitors” to be filled in 
when performing the corresponding...

Datex-Ohmeda S/5 Compact Anesthesia and Compact Critical Care Monitors
2
Document no. M1031518-02                                                                           
Hemodynamic modules w/ (P) InvBP transducer 70077-001
Multi-Link ECG accessories, IEC
E-PSM(P)/ E-PRESTN/ M-PRESTN - Multi-link 3-leadwire set 412682-003
- Multi-link 5-leadwire set 412681-003
- Multi-link 5-leadwire set, C2-C6 416467-004
E-PRESTN/ M-PRESTN w/ (E12) - Multi-link 12-lead ECG trunk cable 416035-002
or Multi-Link ECG...

Planned maintenance instructions
3
                                          Document no. M1031518-02
NOTE: * Ensure that the calibration gas and regulator are functioning properly before calibration. 
Perform annual maintenance on the regulator as required. For more information see section 
“Adjustments and calibrations” in Compact Airway modules slot.
1.2.1 Hemodynamic patient simulators
The following tables present the patient simulators’ compatibility with each hemodynamic module, and the...

Datex-Ohmeda S/5 Compact Anesthesia and Compact Critical Care Monitors
4
Document no. M1031518-02                                                                           
Table 2 Adapter cables for hemodynamic patient simulators
1.3 Recommended parts
M-PRESTN ECG Ok Multilink ECG acc. Not compatible
TOkM1010832 M1010832
InvBP Not compatible Ok Ok
M-NESTPR ECG Not compatible 300 series acc. Ok
12 lead ECG Not compatible 300 series acc. Not compatible
TOkM1010832 M1010832
InvBP Not compatible Ok Ok...