GE S5 Owners Manual

Appendix B ElectroMagnetic CompatibilityB-3(4)
                           Document no. M1187317-009
Table 3 Guidance and manufacturer’s  declaration – electromagnetic 
immunity
Guidance and manufacturer’s decl aration – electromagnetic immunity
The S/5 FM is intended for use in the electromagnetic envi ronment specified below. The customer or the user of the 
S/5 FM should assure that it is used in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment -...

Datex-Ohmeda S/5 FM
B-4(4)
Document no. M1187317-009
Table  4 Recommended separation distances between portable and mobile RF 
communications equipment and the S/5 FM 
(1       For impedance RESP measurement.
Recommended separation distances  between portable and mobile RF 
communications equipment and the S/5 FM.
The S/5 FM is intended for use in an electromagneti c environment in which radiated RF disturbances are 
controlled. The customer or the user of the S/5 FM  can help prevent electromagnetic...

Appendix C, Channel Mask Selections for S/5 FMC-1(2)
                           Document no. M1187317-009
APPENDIX C: Channel Mask Selections for S/5 FM
NOTE: The selections are country specific. Make  sure that you are using the correct selection.
       
Selection Allowed BandDS Channels
07FF 2.400 - 2.4835 01 - 11
1FFF 2.400 - 2.4835 01 - 13
1C00 2.4465 - 2.4835 11 - 13
00F0 2.418 - 2.457 05-08 

Datex-Ohmeda S/5 FM
C-2(2)
Document no. M1187317-009 

Datex-Ohmeda
S/5
TM FM
Planned Maintenance Instructions
Conformity according to the Council Directive 93/42/EEC concerning Medical Devices amended by 2007/47/EC 
CAUTION: U.S. Federal law rest ricts this device to sale by or on the order of a li censed medical practitioner.
Outside the USA, check local laws  for any restriction that may apply.
All specifications subject to change without notice.
Document number M1187318-003
2 February, 2010
GE Healthcare Finland Oy
Kuortaneenkatu 2
FI-00510 Helsinki,...

Table of contentsi
Document no. M1187318-003
Table of contents
1 Planned maintenance instructions 1
1.1 Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1
1.2 Recommended tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . . . . .  2
1.2.1 Hemodynamic patient simulators . . . . . . . . . . . . . . . . . . . . . . ....

Datex-Ohmeda S/5 FM
ii
Document no. M1187318-003 

 Planned maintenance instructions1
Document no. M1187318-003
1 Planned maintenance instructions
1.1 Introduction
These instructions include procedures for planned maintenance (PM) for the Datex-Ohmeda  
S/5 FM. The Planned maintenance should be performed once a year.
These instructions include “Planned maintenance check form, Datex-Ohmeda S/5 FM”  which 
may be used when performing the procedures.
The symbol 
 in the instructions  means that the procedure performed should be signed in 
the check form....

Datex-Ohmeda S/5 FM
2
Document no. M1187318-003
1.2 Recommended tools
NOTE: Use only properly maintained, calibrated and traceable measurement equipment for the 
specified calibrations and adjustments to ensure accuracy.
NOTE: * Ensure that the calibration gas and regulator are functioning properly before 
calibration. Perform annual maintenance on the regulator as required. For more information 
see section “Adjustments and calibrations” in N-FC(REC) slot.
For product(s) Tool Order No.
N-FC(REC)...