GE Logiq P5 Service Manual

GE HEALTHCARE
DIRECTION 5394141, REVISION 1 LOGIQ™ P5 SERVICE MANUAL
Section 3-4 - Preparing for Installation 3-21
3-6-5 Video Specification
Video specifications may be needed to be able to connect the VCR or DVD Video Recorder to the 
LOGIQ™ P5/A5/A5Pro.
Table 3-9    Video Specifications
Timing ParameterNTSCPAL
640x480
60Hz800x60060Hz800x60075Hz1024x768 60Hz
Horizontal Rate [kHz] 60.02 31.25 31.47 37.88 46.88 48.36
Horizontal Period [µ s]16.66 32.00 31.78 26.40 21.33 20.68
Pixel Clock [MHz] 78.75 29.50...

GE HEALTHCARE
DIRECTION 5394141, REVISION  1 LOGIQ™ P5 SERVICE MANUAL 
3-22 Section 3-4 - Preparing for Installation
3-6-6 Setting VCR (Mitsubishi MD3000) USB Interface
1.) Turn off the Power of the VCR.
2.) Open the rear panel of the VCR.
3.) Set dip switches. Off 1~6 pins, On 7 pin, and Off 8 pin.
NOTE: 7 Pin ON = USB Interface, OFF = RS232C Interface.
Figure 3-15   Setting VCR USB Interface 

GE HEALTHCARE
DIRECTION 5394141, REVISION 1 LOGIQ™ P5 SERVICE MANUAL
Section 3-8 - Software/Option Configuration 3-23
Section 3-7
Available Probes
See Specifications in the LOGIQ™ P5/A5/A5Pro User Manual for probes and intended use.
See Chapter 9 , for part numbers to be used when ordering new or replacement probes.
Section 3-8
Software/Option Configuration
refer to the LOGIQ™ P5/A5/A5Pro Basic User Manual, Chapter 16, Customizing Your System for 
information on conf iguring items like Hospital,...

GE HEALTHCARE
DIRECTION 5394141, REVISION  1 LOGIQ™ P5 SERVICE MANUAL 
3-24 Section 3-8 - Software/Option Configuration
Section 3-9
Connectivity Installation Worksheet
Site System Information
Services (Destination Devices) TCP/IP Settings
Device Type
Manufacturer
Name
IP Address Port
AE Title
1
2
3
4
5
6
7
8
9
10
11
12
Name - AE Title:
Dept:
LOGIQ SN:Type:
Floor:
Room:
REV:
Comments:
CONTACT INFORMATION
Name Title
PhoneE-Mail Address
Site:
IP Settings
IP Address:
Subnet Mask:
Default Gateway:
Remote...

GE HEALTHCARE
DIRECTION 5394141, REVISION 1 LOGIQ™ P5 SERVICE MANUAL
Section 3-11 - Loading Base System Software 3-25
Section 3-10
Insite IP Address Configuration
This information needed to facilitate the OnLine Center engineers in connecting to the system is found 
in the InSite Installation Manual.
Section 3-11
Loading Base System Software
3-11-1 Loading Base system Software
For more information on  loading base system software, refer to Chapter 8.
Section 3-12
Warnings
3-12-1 Warnings
3-12-1-1 USB...

GE HEALTHCARE
DIRECTION 5394141, REVISION  1 LOGIQ™ P5 SERVICE MANUAL 
3-26 Section 3-12 - Warnings
Section 3-13
Paperwork
NOTE: During and after installation, the documentation  (i.e. User Manuals, Installation Manuals...) for the 
peripheral units must be ke pt as part of the original system do cumentation. This will ensure that all 
relevant safety and user information is available during the operation and service of the complete 
system.
3-13-1 Product Locator Installation
NOTE: The Product Locator...

GE HEALTHCARE
DIRECTION 5394141, REVISION 1 LOGIQ™ P5 SERVICE MANUAL
Section 4-1 - Overview 4 - 1
Chapter 4
Functional Checks
Section 4-1
Overview
4-1-1 Purpose of Chapter 4
This chapter provides procedures for quickly checking major functions of the LOGIQ™ P5/A5/A5Pro 
scanner diagnostics by using the built-in service software, and power supply adjustments.
Section 4-2
Required Equipment
• An empty (blank) DVD-R or CD-R Disk.
• At least one transducer. Table 4-1    Contents in Chapter 4...

GE HEALTHCARE
DIRECTION 5394141, REVISION  1 LOGIQ™ P5 SERVICE MANUAL 
4 - 2 Section 4-2 - Required Equipment
Section 4-3
General Procedure
4-3-1 Power On/Boot Up
NOTE: After turning off the system, wait at least ten seconds before turning it on again. The system 
may not be able to boot if power is recycled too quickly.
4-3-1-1 Scanner Power On 1.) Connect the Main Power cable to an appropriate mains power outlet.
2.) Switch ON the Main Circuit Breaker at the rear of the System.
When power is applied to...

GE HEALTHCARE
DIRECTION 5394141, REVISION 1 LOGIQ™ P5 SERVICE MANUAL
Section 4-2 - Required Equipment 4 - 3
4-3-1-1              Scanner Power On (cont’d)
3.) Press the  ON/OFF 
key at the front of the System once.
Figure 4-2   Power On/Off  Standby Switch Location 

GE HEALTHCARE
DIRECTION 5394141, REVISION  1 LOGIQ™ P5 SERVICE MANUAL 
4 - 4 Section 4-2 - Required Equipment
4-3-2 Power Off / Shutdown
NOTE: After turning off a system, wait at least ten seco nds before turning it on again. The system may not be 
able to boot if power is recycled too quickly.
4-3-2-1 Scanner Shutdown 1.) Press the On/Off  Key at the front of the System once to display the SYSTEM - EXIT menu.
2.) Select Shutdown from the SYSTEM - EXIT menu.
4-3-2-2 Switch off the System 1.) Switch OFF...