compaq contura 400 family User Manual

9. To replace the display shield, reverse the previous steps.
Removing and Replacing the Display Ground Cable
To remove the display ground cable, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

5. Remove the display cable and backlight cable from the inverter board(Section 3.21).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

11. To replace the display ground cable, reverse the previous steps.
Chapter 3.25 Display Components (Models 420 and 430) 
This section contains removal and replacement procedures for the following 
display assembly components: 
o Bezel 
o Latches 
o Inverter board 
Removing and Replacing the Display Bezel 
To remove the display bezel, follow these steps: 
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2). 

2. Open the computer.
3. Remove the four screws from the display bezel (Figure 3-129).
4. Separate the display bezel from the display assembly (Figure 3-130). 

5. To replace the bezel, reverse the previous steps.
Removing the Display Enclosure Latches and Springs
To remove the display enclosure latches and springs from either side of
the display enclosure, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
3. Remove the display bezel. Refer to Removing and Replacing the Display
Bezel in this section.
4. Hold the bottom of the latch near the spring. Flex the hook end of...

6. Remove the display latch spring from the latch (Figure 3-132). 

Replacing the Display Enclosure Springs and Latches
To replace the display springs and latches, follow these steps:
1. Hook the display latch spring on to the display latch [1] and place the
display latch spring over the post in the display enclosure [2]
(Figure 3-133). 

2. Slide the display latch into place on either side of the display
enclosure (Figure 3-134). 

Removing the Display Inverter Board for the CSTN (10.4 inch) Display
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING >>>>>

location to avoid pinching during the reassembly process. Improper cable
placement can cause severe damage to the unit.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>