compaq contura 400 family User Manual
Here you can view all the pages of manual compaq contura 400 family User Manual. The Compaq manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 171
5. Remove the inverter board (Section 3.21). 6. Remove the display cable and backlight cable from the inverter board (Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 172
8. Carefully rotate the CTFT (8.4 inch) panel down and out of the display enclosure, laying the CTFT (8.4 inch) panel gently on the keyboard assembly (Figure 3-119).
Page 173
9. Remove the display cable from the connector on the back of the panel by pulling the tabs at the back of the connector (Figure 3-120).
Page 174
Replacing the CTFT (8.4 inch) Display Panel To replace the CTFT (8.4 inch) panel, follow these steps: 1. Connect the display cable to the connector on the back of the CTFT (8.4 inch) panel (Figure 3-121).
Page 175
2. Position the CTFT (8.4 inch) panel into the display enclosure, ensuring that the ZIF connector end of the display cable is exposed on the right side of the CTFT (8.4 inch) panel (Figure 3-122).
Page 176
3. Secure the CTFT (8.4 inch) panel with four screws to the display enclosure. Removing the CTFT (8.4 inch) Display Cable To remove the CTFT (8.4 inch) display cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 177
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Page 178
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Page 179
7. Ensure that the cable has been seated evenly and that the white line on the cable is level. 8. Replace the keyboard assembly (Section 3.7). Removing and Replacing the CTFT (8.4 inch) Display Shield To remove the CTFT (8.4 inch) display shield, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 180
4. Remove the inverter board (Section 3.21). 5. Remove the display cable and backlight cable from the inverter board (Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>