compaq contura 400 family User Manual

The ZIF connector and its attached cable can be damaged easily. Handle
only the connector slide when disconnecting the ZIF connector. Never pull
or twist the cable itself while it is seated in the ZIF connector.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

The ZIF connector and its attached cable can be damaged easily. Handle
only the connector slide when disconnecting the ZIF connector. Never pull
or twist the cable itself while it is seated in the ZIF connector.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

7. Ensure that the cable has been seated evenly and that the white line on
the cable is level.
8. Replace the keyboard assembly (Section 3.7).
Removing and Replacing the CTFT (10.4 inch) Display Shield
To remove the CTFT (10.4 inch) display shield, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

4. Remove the inverter board (Section 3.25).
5. Remove the display cable and backlight cable from the inverter board
(Section 3.25).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

9. To replace the display shield, reverse the previous steps.
Removing and Replacing the Display Ground Cable
To remove the display ground cable, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

5. Remove the display cable and backlight cable from the inverter board(Section 3.25).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

11. To replace the display ground cable, reverse the previous steps.
Chapter 3.28 Display Enclosure 
This section provides replacement procedures for the display enclosure. 
Replacing the Display Enclosure
To replace the display enclosure, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2).
2. Remove the handle brackets (Section 3.3). 
3. Remove the tilt feet (Section 3.4).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION 

the display is opened. To prevent damage to the display and the computer,
ensure that the display assembly is opened at a 90-degree angle.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

8. Disconnect the display ground cable [1] from the LIF clip
(Figure 3-172). 

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>