compaq contura 400 family User Manual

11. Lift the display assembly off the system unit module (Figure 3-174). 

12. Position the display assembly top-side up.
13. Remove the display bezel (Section 3.25).
14. Remove the display latches and springs (Section 3.25).
15. Remove the inverter board (Section 3.21).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

placement can cause severe damage to the unit.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

21. Replace the display ground cable, the LCD panel, the shield, and the
display cable into the display enclosure as follows:
- If replacing a Monochrome panel and shield, refer to Section 3.22.
- If removing a CSTN (9.5 in) panel and shield, refer to Section 3.23.
- If removing a CTFT (8.4 in) panel and shield, refer to Section 3.24.
- If removing a CSTN (10.4 in) panel and shield, refer to Section
3.26.
- If removing a CTFT (10.4 in) panel and shield, refer to Section 3.27.
22. Connect the display...

27. Align the clutches with the system unit module, ensuring that the
display ground cable and the display cable are positioned on top of
the system unit module (Figure 3-178). 

28. Replace the four rear clutch screws (Figure 3-179). 

29. Open the display to a 90-degree angle (Figure 3-180). 

30. Connect the display ground cable [1] to the LIF clip above the serial
port connector between the system board and the system chassis
(Figure 3-181). 

31. Carefully insert the end of the cable into the ZIF connector slide on
the system unit.
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it. Before closing the slide, ensure that the
cable is fully seated (to the white insertion line) in the
ZIF connector.
32. While holding the end of the display cable inside the ZIF connector
slide, press down both ends of the slide simultaneously to secure the
cable in the...

33. Ensure that the cable has been seated evenly and that the white line
on the cable is level.
34. Replace the right clutch ground clip located between the clutch and
the CPU base. The right clutch clip for Models 420 and 430 is
different and is illustrated in the insert Figure 3-183).