compaq contura 400 family User Manual

7. Connect the display cable and the backlight cable to the inverter
board (Section 3.25).
8. Replace the inverter board (Section 3.25).
9. Replace the bezel (Section 3.25).
10. Connect the display ground cable [1] from the LIF clip above the serial
port connector (Figure 3-156). 

11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board.
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it. Before closing the slide, ensure that the
cable is fully seated (to the white insertion line) in the
ZIF connector.
12. While holding the end of the display cable inside the ZIF connector
slide, press down both ends of the slide simultaneously to secure...

13. Ensure that the cable has been seated evenly and that the white line
on the cable is level.
14. Replace the keyboard assembly (Section 3.7).
Chapter 3.27 Color TFT (10.4 inch) Display (Models 420 and 430) 
IMPORTANT: The Monochrome, CSTN and the CTFT displays have different
removal and replacement procedures. Be sure to follow the
procedures for the specific display.
This sections contains removal and replacement procedures for the
following CTFT (10.4 inch) display components:
o Display panel
o...

Removing the CTFT Display Panel
To remove the CTFT (10.4 inch) panel, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>

NOTE: The CTFT (10.4 inch) display is different than all other displays.
The inverter board fits partially behind the display. Loosen the
screws on the display to slide the inverter out from behind the
display.
5. Remove the inverter board (Section 3.25).
6. Remove the display cable and backlight cable from the inverter board
(Section 3.25).
7. Remove the four screws that secure the CTFT (10.4 inch) panel to the
display enclosure (Figure 3-159). 

8. Carefully rotate the CTFT (10.4 inch) panel down and out of the display
enclosure, laying the CTFT (10.4 inch) panel gently on the keyboard
assembly (Figure 3-160). 

9. Remove the display cable from the connector on the back of the panel
(Figure 3-161). 

10. The CTFT Display Cable is disconnected by pulling upward on the tabs
on the back of the Connector.
Replacing the CTFT (10.4 inch) Display Panel
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

2. Position the CTFT (10.4 inch) panel into the display enclosure, ensuring
that the ZIF connector end of the display cable is exposed on the right
side of the CTFT (10.4 inch) panel (Figure 3-163). 

3. Secure the CTFT (10.4 inch) panel with four screws to the display
enclosure.
Removing the CTFT (10.4 inch) Display Cable
To remove the CTFT (10.4 inch) display cable, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>