compaq contura 400 family User Manual

17. Lift the display ground cable out of the display enclosure
(Figure 3-109). 

Replacing the Display Ground Cable, Display Cable, Shield, and the CSTN
(9.5 inch) Panel
To replace the display ground cable, the display cable, the shield, and
the CSTN (9.5 inch) panel, follow these steps:
1. Position the display ground cable in the display enclosure, aligning
the cable with the bosses in the display enclosure (Figure 3-110). 

2. Connect the display cable to the connector on the back of the CSTN (9.5
inch) panel (Figure 3-111). 

3. Slightly lift the tabs on the left side of the display shield and slide
the shield onto the CSTN (9.5 inch) panel. Ensure that the LIF
connector end of the display cable is exposed on the right side of the
CSTN (9.5 inch) panel (Figure 3-112). 

4. Place the display shield tabs in the indentations on the sides of the
CSTN (9.5 inch) panel (Figure 3-113). 

5. Align the CSTN (9.5 inch) panel, display cable, and shield in the
display enclosure and replace the screws. Ensure that the ZIF
connector end of the display cable and the end of the display ground
cable are exposed at the bottom of the display enclosure
(Figure 3-114). 

6. Connect the display cable and the backlight cable to the inverter board
(Section 3.23).
7. Replace the inverter board (Section 3.23).
8. Replace the bezel (Section 3.23).
9. Connect the display ground cable [1] from the LIF clip above the serial
port connector (Figure 3-115). 

10. Carefully insert the end of the display cable into the ZIF connector
slide on the system board.
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it. Before closing the slide, ensure that the
cable is fully seated (to the white insertion line) in the
ZIF connector.
11. While holding the end of the display cable inside the ZIF connector
slide, press down both ends of the slide simultaneously to secure the
cable...

12. Ensure that the cable has been seated evenly and that the white line
on the cable is level.
13. Replace the keyboard assembly (Section 3.7).
Chapter 3.24 Color TFT (8.4 inch) Display (Models 400 and 410) 
IMPORTANT: The Monochrome, CSTN and the CTFT displays have different
removal and replacement procedures. Be sure to follow the
procedures for the specific display.
This sections contains removal and replacement procedures for the
following color CTFT (8.4 inch) display components:
o Display panel
o...

Removing the CTFT (8.4 inch) Liquid Crystal Display Panel
To remove the CTFT (8.4 inch) panel, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>