compaq contura 400 family User Manual

Chapter 3.19 System Chassis (All Models) 
To remove the system chassis, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Remove the handle bracket on either side of the computer (Section 3.3).
3. Remove the tilt feet on either side of the computer (Section 3.4).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

7. Remove the four clutch screws from the rear of the system unit module
(Figure 3-71).
8. Remove the display assembly from the system unit module (Figure 3-72). 

9. Slide the trough at the rear of the CPU base to the right, then lift up
to remove (Figure 3-73). 

10. Remove the system chassis by gently separating it from the CPU base
and lifting out the system chassis (Figure 3-74). 

11. To replace the system chassis, reverse the previous steps.
Chapter 3.20 CPU Base (All Models) 
This section provides removal and replacement procedures for the following
CPU base components:
o Battery shield clip
o Lock provision plate
o Anti-skid pads
Removing and Replacing the Battery Shield Clip
To remove the battery shield clip, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2). 

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

1. Peel off the top layer of one of the anti-skid pads to expose the
adhesive.
2. With the adhesive-side down, place the anti-skid pad into the raised
oval outline on the CPU base and the battery tray (Figure 3-77).
Chapter 3.21 Display Assembly Components (Models 400 and 410) 
This section contains removal and replacement procedures for the following
display assembly components:
o Bezel
o Latches
o Inverter board
Removing and Replacing the Display Bezel
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING 

serious injury or damage to the equipment.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

5. To replace the bezel, reverse the previous steps.
Removing the Display Enclosure Latches and Springs
To remove the display enclosure latches and springs from either side of
the display enclosure, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Open the computer.
3. Remove the display bezel. Refer to Removing and Replacing the Display
Bezel in this section.
4. Hold the bottom of the latch near the spring. Flex the hook end of...