compaq contura 400 family User Manual

7. Replace the battery pack and reconnect the AC power.
Chapter 3.14 Diskette Drive (All Models) 
This section contains removal and replacement procedures for the following
diskette drive components:
o Diskette Drive
o Diskette Drive Bracket
o Diskette Drive Insulator Strip
Removing the Diskette Drive
To remove the diskette drive, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

Removing the Diskette Drive from the Diskette Drive Bracket
1. Remove the diskette drive from the system chassis. Refer to Removing
the Diskette Drive in this section.
2. Remove the diskette drive from the bracket by removing the four screws
from both sides of the bracket (Figure 3-44). 

3. Separate the diskette drive from the bracket (Figure 3-45). 

4. To replace the diskette drive into the bracket, reverse the previous
steps.
Applying the Diskette Drive Hook and Loop Fastener
If installing a new diskette drive bracket, the hook and loop fastener
must be attached to the bracket.
To attach the hook and loop fastener, follow these steps:
1. Separate the new hook and loop fastener.
2. Remove the backing from the adhesive on the hook and loop fastener that
is the opposite color of the hook and loop fastener attached to the
keyboard assembly (for...

Replacing the Diskette Drive
To replace the diskette drive into the system chassis, follow these steps:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

4. Reconnect the Diskette Drive Cable and reinstall the three screws.
Chapter 3.15 The System Board (All Models) 
To remove the system board, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Remove the hard drive (Section 3.5).
3. Remove the memory expansion board, if installed (Section 3.6).
4. On the rear of the computer, use a hex socket driver to remove the six
screw locks (Figure 3-48).
5. Using a Torx-T8 driver, remove the...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>

10. Disconnect the display cable from the system board by pulling up both
ends of the ZIF connector slide simultaneously [1], carefully opening
the slide [2] (Figure 3-49).
11. Lift the display cable out of the connector slide [3], being careful
not to pull or twist the cable (Figure 3-49).
12. Disconnect the display ground cable [1] from the LIF clip above the
serial port connector (Figure 3-50).