compaq contura 400 family User Manual
Here you can view all the pages of manual compaq contura 400 family User Manual. The Compaq manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 141
12. Carefully remove the Monochrome LCD panel, display cable, and shield from the display enclosure (Figure 3-90).
Page 142
13. Lay the Monochrome LCD panel face down on a clean surface. 14. Grasp the sides of the shield near the backlight cable. Flex the shield away from the Monochrome LCD panel. Ensure that the shield tabs and finger grips clear the LCD panel (Figure 3-91).
Page 143
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 144
17. Lift the display ground cable out of the display enclosure (Figure 3-93).
Page 145
Replacing the Display Ground Cable, the Display Cable, the Shield, and the Monochrome Panel To replace the display ground cable, the display cable, the shield, and the Monochrome LCD panel, follow these steps: >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 146
2. Replace the display cable on the monochrome LCD panel by carefully inserting the end of the display cable into the ZIF connector slide on the LCD panel (Figure 3-95). IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated in the ZIF connector. 3. While holding the end of the display cable inside the ZIF connector slide, press down both ends of the...
Page 147
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Page 148
5. Place the shield tabs in the indentations on the right side of the Monochrome LCD panel (Figure 3-97).
Page 149
6. Align the Monochrome LCD panel, shield, and cable in the display enclosure and replace the screws. Ensure that the ZIF connector end of the display cable and the end of the display ground cable are exposed at the bottom of the display enclosure (Figure 3-98).
Page 150
![Page 150
7. Connect the display cable and the backlight cable to the inverter board
(Section 3.21).
8. Replace the inverter board (Section 3.21).
9. Replace the bezel (Section 3.21).
10. Connect the display ground cable [1] to the LIF clip above the serial
port connector (Figure 3-99).
11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board (Figure 3-99).
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while...](http://img.usermanuals.tech/thumb/1258/38919/w300_compaq-contura-400-family-149.png "Page 150
7. Connect the display cable and the backlight cable to the inverter board
(Section 3.21).
8. Replace the inverter board (Section 3.21).
9. Replace the bezel (Section 3.21).
10. Connect the display ground cable [1] to the LIF clip above the serial
port connector (Figure 3-99).
11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board (Figure 3-99).
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while...")
7. Connect the display cable and the backlight cable to the inverter board (Section 3.21). 8. Replace the inverter board (Section 3.21). 9. Replace the bezel (Section 3.21). 10. Connect the display ground cable [1] to the LIF clip above the serial port connector (Figure 3-99). 11. Carefully insert the end of the display ground cable into the ZIF connector slide on the system board (Figure 3-99). IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while...