compaq contura 400 family User Manual

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

rails are assembled properly into the PC Card Header. The rail goes
under the edge of the header. Tighten the header screws from the bottom
of the system board.
Removing the PC Card (PCMCIA) Rails
NOTE: The rails for the 400 and 410 models are not interchangeable with
the rails for the 420 and 430 models.
To remove the PC Card rails, follow these steps.
1. Remove the PC Card clips. Refer to Removing the PC Card Clip in this
section.
2. Slide the rails out of the header (Figure 3-61).
3. To replace the PC...

This section contains removal and replacement procedures for the PC Card
ejection levers and pin.
To remove the PC Card ejection levers and pin, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
2. Remove the PC Card ejection lever pin from the system chassis
(Figure 3-62).
3. Remove the top PC Card (PCMCIA) ejection lever (Figure 3-63). 

4. Remove the bottom PC Card ejection lever from the boss on the CPU base
(Figure 3-64) 

5. To replace the PC Card ejection levers and pin, reverse the previous
steps.
Chapter 3.18 PC Card (PCMCIA) Doors and Springs 
This section contains removal and replacement procedures for the PC Card
doors and springs. The top PC Card door and spring are located on the
keyboard assembly and the bottom PC Card door and spring are located on
the CPU base.
Top PC Card Door and Spring
To remove the top PC Card door and spring, follow these steps:
1. Disconnect all power from the computer and remove the AC...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-67). 

Bottom PC Card (PCMCIA) Door and Spring
The bottom PC Card door and spring are located on the CPU base. To remove
the bottom PC Card door and spring, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

To replace the bottom PC Card (PCMCIA) spring and door, follow these steps:
1. Install the PC Card spring on the door post, making sure the bent arm
of the spring is placed against the rib on the PC Card door
(Figure 3-69). 

2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-70).