compaq contura 400 family User Manual

14. Lay the CSTN (10.4 inch) panel face down on a clean surface.
15. Slide the display shield off the CSTN panel (Figure 3-146). 

16. Only Sharp panels require the XOVER Board. Remove the ground wire
connecting the XOVER Board with the CSTN (10.4 inch) Panel
(Figure 3-147). 

17. Disconnect the display cable from the connector on the back of the
CSTN (10.4 inch) panel (Figure 3-148). 

17. Lift the display ground cable out of the display enclosure
(Figure 3-149). 

Replacing the Display Ground Cable, Display Cable, Shield, and the CSTN
(10.4 inch) Panel
To replace the display ground cable, display cable, shield, and the CSTN
(10.4 inch) panel, follow these steps: 

1. Position the display ground cable in the display enclosure, aligning
the cable with the bosses in the display enclosure (Figure 3-151).
2. If the CSTN panel is manufactured by Sharp complete this step. If not,
continue to step 4. Connect the display cable to the XOVER Board. Then
connect the XOVER Board to the connector on the back of the CSTN (10.4
in) panel. Attach the ground wire of the XOVER Board to the display
panel as indicated in (Figure 3-151). 

3. If the CSTN panel is manufactured by Sharp complete this step. If not,
continue to the next step. Peel off the adhesive from the back of the
rubber pad found in the spare kit. Place this pad on the display
enclosure indicated by the embossed area (Figure 3-152). 

4. Slightly lift the tabs on the left side of the display shield and slide
the shield onto the CSTN (10.4 inch) panel. Ensure that the LIF
connector end of the display cable is exposed on the right side of the
CSTN (10.4 inch) panel (Figure 3-153). 

5. Place the display shield tabs in the indentations on the sides of the
CSTN (10.4 in) panel (Figure 3-154). 

6. Align the CSTN (10.4 inch) panel, display cable, and shield in the
display enclosure and replace the screws. Ensure that the ZIF connector
end of the display cable and the end of the display ground cable are
exposed at the bottom of the display enclosure (Figure 3-155).