Toshiba Strata Dk24, Dk56, Dk96 Instruction Manual

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS 
SECTION 200-096-302 
FEBRUARY 1991 
1 GENERAL 
1.00 
This chapter consists of System Record 
Sheets, and instructions on how to fill out each of 
the them. The chapter begins with the instructions: 
first the basic program, followed by toll restriction, 
and then least cost routing. The remainder of 
the chapter contains the system record sheets, 
organized in the same sequence as the 
instructions. 
1 .I 0 Record Sheet Data Entry 
1 .I 
1 
The system...

PROGRAMMING PROCEDURES-INSTRUCTIONWSYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
will have to be carefully worked out. All User 
Guides are written using the standard access 
codes and station numbers. If desired, an 
electronic telephone accompanying a DSS 
console (or a digital telephone accompanying 
a DDSS console) can have a station number of 
0 or 01, etc. without conflict. If no assignment 
is made in 
Program 04, the system, upon 
powering up, will automatically assign eight 
station numbers...

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
system will allow “blind” transfers-the 
transferring station may release a trans- 
ferred call before the called party answers. 
If not allowed, the system will allow super- 
vised station must 
answer before the transferring station re- 
leases. If Ring Transfer is not allowed, 
immediate recall occurs if “blind”transfer is 
attempted. 
l CO Repeat Ringing, LED 06-If selected, 
the incoming ringing timing pattern at a...

PROGRAMMINGPROCEDURES-INSTRUCTIONWSYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
assigned in Program 30) to break into and 
overhear an existing station conversation. 
A warning tone can be set optionally to be 
heard by the conversing parties. 
l External Page Included with All Call 
Page, LED 
15-If the all call voice page 
access code (39) is dialed, external page 
(all zones) may be included or omitted with 
this option. This option does not affect the 
All Call (m) button function; them button...

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
voice mail system that sets station Mes- 
sage Waiting (MW) LEDs by dialing Ii+ 
station number. This insures the message 
LED remains flashing until all VM mes- 
sages have been retreived, at which time 
the VM machine should cancel the MW 
LED by dialing Ii+ station number. With 
Dial 11 enabled, MW indications set on a 
station from Voice Mail ports will not auto- 
matically be cancelled by the DK system 
when the...

PROGRAMMING PROCEDURES-INSTRUCTIONWSYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
line, a station user can press the Message 
Waiting/Flash button and the CO line will 
open (flash) for a period of either 2 sec- 
onds, 0.2 seconds or 0.5 seconds depend- 
ing on this assignment. A flash can also 
be activated by dial code-II. 
In general, this choice reflects whether to 
disconnect and regain dial tone (2 sec- 
onds),ortousePBXorCENTREXfeatures 
which require a flash signal (0.5 seconds). 
This flash...

IMPORTANT NOTE: 
This option can not always be utilized 
because some Central Offices may send 
unreliable AR signaling or no AR signal- 
ing. 
0 
0 
I 
0 AR Time, Code 4-AR signaling timing is 
different depending on the Central Office 
equipment. An assignment choice exists 
between Crossbar or ESS Central Offices. 
Tandem CO Line Connection, Code 5- 
Once a two CO line conference call is 
made by an electronic or digital telephone 
user, that user may drop out of the con- 
ference and optionally leave...

PROGRAMMINGPROCEDURES-INSTRUCTIONWSYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
connected to a PSTU or PDKU station 
circuit. 
Program 20-Data Interface Unit (DIU: PDIU-DI 
and PDIU-DS) Configuration (Release 3): 
This program identifies the PDKU station ports 
connected to DlUs and the type of DIU connected. 
NOTE: 
DlUs can be connected to ports associated 
with PDKU circuits 1 - 7. 
l LED Ol- Light this LED if there is a PDIU-DI or 
PDIU-DS connected to the PDKU port. Each 
PDIU-DI (integrated...

PROGRAMMINGPROCEDURES-INSTRUCTIONSKXTEMRECORDS 
SiCTlON 200-096-302 
FEBRUARY1991 
2. Digitaltelephones with PDIU-Dls thatmusi 
access modems from a pool require a 
m button assigned in 
Program 39. 
3. PDKU/PDIlJ-DS ports that are connected to 
modems in the modern pool should be set with 
LEDs 01, 02, 03, and 
04 “0N”in Program 20. 
4. If a modem connected to PDIU-DS is 
connected to a telephone network CO 
line, instead of a PSTU or PESU station 
port, 
Program 21 should not be used. 
5. Use Program...

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS 
SECTION 200-096-302 
FEBRUARY1991 
I 
Privacy Override. Privacy Override of DISA 
two-CO line calls is not allowed. 
NOTES: 
1. To configure the DK system to operate as 
nonpriva te, allow privacy override from all 
stations. 
2. Privacy override can be blocked by a 
station via the PRIVACYbutton (Program 
39) or by the executive/privacy blocking 
option (Program 31, LED 18). 
3. See Table 2-C at the end of this chapter. 
l Executive Override, LED...