Toshiba Strata Airlink Integrated Wireless Handset User Guide

							The Grand Tour
Battery
Strata AirLink Integrated Wireless Handset 5/999
Removing and Re-installing the Battery
CAUTION!If you have to remove the battery, turn off the power first. This 
saves your menu changes and Speed Dial (SD) additions since the 
last time you turned on the power.
ä
ää ä
To remove the battery
1. Press the battery release in the direction 
of the arrow (shown at right).
2. Lift out the battery.
ä
ää ä
To re-install the battery
1. Fit the battery notches into the base 
of the handset (shown at right).
2. Snap the upper part of the battery into 
the handset.
3019Battery Release
3020
Handset Battery
XX
XX
Handset without Battery
Notches 
						

							The Grand Tour
Battery
10Strata AirLink Integrated Wireless Handset 5/99 
						

							Strata AirLink Integrated Wireless Handset 5/9911
Installation2
This chapter describes installation procedures and how to charge the handset 
batteries.
Important!The Strata AirLink Wireless System must be programmed before the 
handset operates.
Step 1: Select Location
1. Select a location for your handset and Charger Base. Avoid excessive heat or 
humidity.
2. Place the handset and charger on a desk or tabletop near a standard 120V AC 
outlet.
3. Keep the handset away from sources of electrical noise (motors, fluorescent 
lighting, etc.) 
						

							Installation
Battery
12Strata AirLink Integrated Wireless Handset 5/99
Step 2: Charge Batteries for First Time
1. Remove the handset carrying case, if it has 
one.
2. Make sure the power is off.
3. Insert the handset (battery in it) in the front 
slot of the charger (shown at upper right). 
The Handset LED changes to amber and 
then to red, indicating rapid charging.
NoteIf you place a fully charged battery in 
the charger, it detects the full charge 
and cancels rapid charging. The 
Handset LED changes to amber, red, 
and then green.
4. If you have a spare battery, insert it in the 
rear slot of the handset charger (shown at 
lower right).
The Battery LED changes to amber while 
waiting for the handset to finish charging 
or alternates between green and amber, 
indicating discharge is in progress.
5. Remove the handset or spare battery when 
the LEDs change to a steady green. 
The steady green LED indicates a fully 
charged battery. The charger switches to a 
“trickle charge” until you remove the 
handset or spare battery.
FLSH PWR
FCN
STO
CALL
END
CLR
1
23
4
56
7
89
ã
0RCL
ABC
ABC
DEF
MNO JKL
*
GH I
PQRS
TUV
#WXYZ
3911
Handset LED
3912
Battery LED 
						

							Installation
Battery
Strata AirLink Integrated Wireless Handset 5/9913
Important!Do not use the battery before it has completed the rapid charge cycle, 
even if the handset battery icon displays full strength. The battery 
must charge for two continuous hours. Reduced talk/standby time 
result under these conditions.
Step 3: Verify Call Ringing Patterns
Your handset ringing pattern is set in system programming. Some systems use the 
internal call ring pattern for incoming outside calls – one second on, three seconds 
off. A distinct outside call ring pattern is available – 0.4 seconds on, 0.2 seconds off, 
0.4 seconds on, three seconds off. 
Step 4: Verify System/Handset IDs
Your System Administrator programs one or more system IDs into your handset. 
This enables you to roam or handoff calls in one or more telephone systems. See 
your System Administrator to program additional system IDs into your handset. 
						

							Installation
Battery
14Strata AirLink Integrated Wireless Handset 5/99 
						

							Strata AirLink Integrated Wireless Handset 5/9915
Handset Operation3
This chapter describes handset operation, including powering on and off, menu 
functionality, and SD. Your handset can be configured for digital or standard 
operation. See Chapter 4 - Digital Features and Chapter 5 - Standard Features for 
features specific to each handset.
Powering On and Off
i
Press 3:5 (toggles 
on or off).The handset beeps. 
NoteStrata DK system time appears shortly after 
the handset is first powered on.
TOSHIBA
_ 1 _DEC_98
12 : 15 
						

							Handset Operation
Making Calls
16Strata AirLink Integrated Wireless Handset 5/99
Making Calls
You can make calls outside the telephone system by dialing direct or using CO Line 
Access Codes. See “CO Line Access Codes”on Page 109 for more information.
ä
ää ä
To make an internal call
Receiving Calls
i
Enter a telephone 
number and press 
&$//
If the called number is 
forwarded, this displays: 
Then, the Call Forward 
destination number [
210] 
displays.
...or press 
&$// first 
and the telephone 
number.You hear dial tone and your call is connected.
i
Press 
&$//. The call connects.
NoteAuto Answer mode connects to a call without 
pressing 
&$//.
CALL I NG
00015
CALL FORW
ARD TO
00025
TALK TO
210
00025 
						

							Handset Operation
Menu Options
Strata AirLink Integrated Wireless Handset 5/9917
Menu Options
The handset must be idle to use its own menu. Ta b l e  2 describes each option.
ä
ää ä
To access menu options
  
1. Press )&1 + s
The LCD scrolls backward through menu options 
13~1.
...or 
)&1 + t
. It scrolls forward through menu options 1~13 .
2. Press 
)&1 again 
when the desired 
option displays.Important!You must turn the power off first or all 
menu changes, except to the idle 
message, are lost if you remove the 
handset battery.
Table 3 Menu Options
PressOption
5#.#)&1
)&1)&1 )&1
Sets Ringer Type
6#.#)&1
)&1)&1 )&1
Sets Ringer Volume
7#.#)&1
)&1)&1 )&1
Adjusts Button Beep Volume
9#.#)&1
)&1)&1 )&1
Sets Time Format
:#.#)&1
)&1)&1 )&1
Turns Auto Answer On/Off
;#.#)&1
)&1)&1 )&1
Sets Display Contrast

						

							Handset Operation
Menu Options
18Strata AirLink Integrated Wireless Handset 5/99
Auto Answer (: + )&1)
Change Idle Message (
46 + )&1,
Important!
Do not use the full 18 characters because the date displays also. 1. Press 
)&1 + t
 
(seven times)
...or 
: + )&1.
2. Press 
)&1 to toggle 
onNoteWhen a call comes in, 
you only hear a 
“click,” similar to the 
click you hear when 
you press a button.
...or toggle off.
3. Press 
(1. Clears the display and saves the last selected value.
1. Press 
)&1 + t
 (13 
times)
...or 
46 + )&1.
2. Press 
)&1#again. The handset changes to 
alpha mode and displays the 
“ABC” icon. The current 
message displays.
AUTO
ANSWER
fn:07
AUTO ANSR
ON
fn:07
AUTO ANSR
OFF
fn:07
CHANGE
IDLE MSG
fn:13
fn:13
ABC