Siemens Saturn Iie Epabx General Description Manual

SATURN IIE EPABX 
Maintenance and Troubleshooting 
RMTE - 
ACT 
LED 
(Green) 
TTY0 - 
Connector 
TTY1 - 
Connector 
Figure 2.03 Remote Access Unit/Ports Printed Circuit Board (RAUP)  

I 
- 
SATURN IIE EPABX 
Maintenance and Troubleshooting 
2.08 Manual On-Line Diagnostic Tests. The SATURN IIE 
EPABX software includes a group of system diagnostic and 
apparatus diagnostic test programs which are used via the 
maintenance phone. Resulting visual and/or audible 
responses from these tests make it possible to verify correct 
operation or detect and isolate system and apparatus mal- 
functions. 
2.09 System Diagnostic Tests. The system diagnostic pro- 
grams permit calls and procedures to...

SATURN IIE EPABX 
Maintenance and Troubleshooting 
I 
--. 
A30808-X5130-DllO-l-8920 
Issue 1, May 1986 
the basic slot number to designate the second eight 
circuits on an SLA16 PCB). When this procedure is 
enabled, it allows existing calls on the circuits to be 
completed before being taken out of service. If the 
procedure fails, because the selected circuit is either 
invalid or unassigned, reorder tone is returned. Suc- 
cessful completion of the procedure is indicated by the 
return of confirmation...

SATURN IIE EPABX 
Maintenance and Troubleshooting A30808-X5130-DllO-l-6920 
Issue 1, May 1986 
that the operation of certain buttons (and 
SuCCeSSful test completion) is indicated at the end of the test by 
the return of ringback tone and actuation of the audi- 
ble alerting device in the JR-DYAD Telephone. 
e. Siemens Digital Telephone - DYAD Display Test. This 
test checks the signalinghighways to and from a DYAD 
Telephone, its display module, and audible alerting 
device. The DYAD Telephone display...

SATURN IIE EPABX 
Maintenance and Troubleshooting 
or DCI, a PIMD error message is recorded in the failure 
history memory and the minor alarm indicators are 
lighted. 
k. Presence Alarm Test. The scan data returned for each 
port circuit contains a presence bit. If the presence bit 
goes inactive for 3 seconds or changes state (active/in- 
active) six times in 3 seconds, a presence alarm mes- 
sage is recorded in the failure history memory and the 
minor alarm indicators are lighted. The presence alarm...

I 
_-. 
SATURN IIE EPABX 
Maintenance and Troubleshooting 
back and, if it matches the original data, the data 
device is considered to be fully operational and other 
idle data devices are located for testing. If the first loop- 
back test fails, the associated SLMD is looped-back 
and the data pattern test is repeated. If the second test 
fails, an SLMD fault is suspected; if the second test 
passes, a DCI failure or wiring fault is suspected. When 
either or both tests fail, the PEN of the failed...

SATURN IIE EPABX A30808-X5130-DllO-1-5920 
Maintenance and Troubleshooting Issue 1, May 1986 
. 
Q 
: : 
LTU 
PS 
0 
It. -00~1~-2-~3~-4---7r5~r6~ 
-COMMON EOUIPMENT- 
LTU 
Shelf 
Basic 
Shelf 
Figure 2.04 SATURN IIE EPABX Basic Cabinet (Front View)  

I - 
SATURN IIE EPABX 
Maintenance and Troubleshooting A30808-X5130-DllO-1-6920 
Issue 1, May 1986 
LTU 
Shelf 1 
Basic 
Shelf 
A5?56-I-4/21186 Figure 2.05 SATURN IIE EPABX Basic Cabinet (Rear View) 
2-13  

SATURN IIE EPABX 
Maintenance and Troubleshooting A30808-X5130-DllO-l-8920 
Issue 1, May 1986 
[df SATIIRN II F 
P, c3 
LTU LTU Shelf 3 
PS2 
0 
0 B 
c? Q 
LTU 
PSI LTU Shelf 2 
LTU Shelf 1 
11 Basic Shelf 
1 
I 1 i 
Expansion 
Cabinet 
’ 
Basic 
Cabinet 
Figure 2.06 SATURN IIE EPABX Basic and Expansion Cabinets (Front View) 
.  

1 
- 
SATURN IIE EPABX 
A30808-X5130-DllO-l-8920 
Maintenance and Troubleshooting 
Issue 1. May 1986 
LTU 
Shelf 3 
LTU 
Shelf 2 
LTU 
Shelf 1 
Basic 
Shelf 
Figure 2.07 SATURN IIE EPABX Basic and Expansion Cabinets (Rear View) 
2-15