Siemens Saturn Iie Epabx General Description Manual

SATURN IIE E?ABX A30808-X5130-8120-l-8928 
Installation Test Procedures issue 1, May 1986 
TEP 
1 Place maintenance test phone 
off-hook. Dial tone returned. 
2 Dial the Diagncstic Test Access Code. Recall dial tone returned. 
3 
4A Dial 1 for tone generator test. None. 
Dial 00 if all tones are to be tested and 
verify that all tones returned are un- 
dis!orted. All tones are returned in the sequence 
shown in Table 6.01 for two seconds 
each: test repeats until the main- 
tenance test phone is placed...

I 
SATURN IIE EPABX A30808-X5130-B120-l-8928 
Installation Test Procedures Issue 1, May 1986 
STEP PROCECURE VEFHFICATION 
1 
5 
6A 
68 Table 6.02 DTMF Receiver Test 
Place maintenance test phone 
off-hook. 
Dial the Diagnostic Test Access Code. 
Dial # for DTMF receiver test. 
Dial the four-digit PEN number of the 
DTMF receiver circuit to be tested. 
Depress the maintenance test phone 
keypad’s buttons in the following se- 
quence. Test tone (1004Hz at -16dBm) 
returned. 
a) For 12-button phones: 1, 2,...

SATURN IIE EPABX 
Installation Test Procedures A30808-X5130-B120-l-8928 
Issue 1, May 1986 . 
Tab!c A.03 Station Line Test fCnntinc)edl 
, STEP 
PROCEDURE 
\-----------I 
STEP FROCEDUZZ VERIFICATTION IF VER!FiCATION 
IS NOT OBTAINED ’ 
7 Place station under test on-hook. Ringing returned. 
If ringing is not heard, switch the sta- 
tion instrument to determine if it is 
defective. If ringing is still not heard, 
replace the associated subscriber line 
PCB. 
8 Pick up handset to answer test tail. 
9 Verify...

SATURN IIE EPABX A30808-X5130-B120-l-B928 
instaliation Test Procedures Issue 1, May 1986 
Wbtc 6.04 DTMF Pad Test 
STEP PWO@EDWE VERIFICATION IF VERIFICATIGN 
IS NOT OBTAINED 
7 Depress the DTMF keypad buttons in Recall dial tone ceases. After all the If busy tone is returned at any time, 
the following sequence: DTMFjteypad buttons are depressed either the DTMF key pad buttons were 
in the sequence indicated, test tone depressed in the wrong sequencethe 
For 12-button phones: 1, 2, 3, 4, 5, 6, (1004Hz...

SATURN IIE EPABX A30808-X5130-B120-l-8928 
Installation Test Procedures Issue 1, May 1986 
Table 6.05 Console Test (Continued) 
:TE? PRCCEDURE VERIFICATIDN lF VERlFlCATlON 
IS NOT OBTAINED + 
6 Depress the console’s keypad buttons All digits dialed are displayed (ac- If proper verification is not obtained or 
in the following sequence: 1, 2, 3, 4, cumulate). busy tone is returned at any time, the 
5, 6, 7, 8, 9, 0, * and #. keypad buttons or console buttons 
were depressed out of sequence, the 
7 Depress...

I 
- 
SATURN IIE EPABX 
A30808-X5130-8120-143928 
installation Test Procedures 
Issue 1, May 1986 
TRUNK GGOUPSTATUS 
nnnnnnnn k 
(ALPHANUMERIC DISPLAY LNI;) 
SOUlxi OESTIXATION 
00000000 
li 18 19 20 21 22 23 24 
ALERT CL1 
Figure 6.19 Attendant Console Keypad and Feature Button Depression Sequence  

SATURN IIE EPABX 
A30808-X5130-B120-l-6926 
Installation Test Procedures 
Issue 1, May 1986 
Table 6.06 Attendant Console Displayable Characters 
ORDER 
1. 
2. 
3. 
4. 
5. 
6. 
7. 
8. 
9. 
10. 
11. 
12. 
13. 
14. 
15. 
16. 
17. 
18 19. 
20. 
2’:. 
23: 
24. 
25. 
26. 
27. 
28. 
29.  30. 
31. 
32. CHARACTER 
I I I I I I ! ! 
;;;;,A!,;;;; 
$$$$5$$$ 
o/o o/o 010 o/o o/o o/o o/o % 
&&&&&&&& 
I I I I I I I I 
( ( ( ( ( ( ( ( 
) 1 1 1 1 1 1 1 
* l * * * l * * ++++++++ 
I I > 9 I 1 3  I 
- - - - - - - - 
i i i i...

I . 
SATURN IIE EPABX A30808-X5130-B120-I-6928 
Installation Test Procedures Issue 1, May 1986 
Table 6.07 Siemcns Digital Telephone - DVAD Dutton Test 
NOTES: 1) If the system option flag TSTDIAG has been enabled in the data base or the Siemcns Digital Telephone under 
test is classmarked with TSTAPP feature, the maintenance test phone is nbt required to enable or disable the 
Apparatus Diagnostic routines; therefore, perform only steps 5 through 9. 
2) If the system option flag TSTDIAG has been...

I 
- 
SATURN HE EPABX 
Installation Test Procedures A30808-X5130-8120-1-8928 
Issue 1, May 1986 
IS BUTTON 
DYAD 
26 BUTTON 
DYAD 
SEE NOTE 
NOTE: These buttons do not 
contain LEDs. 
SEE NOTE y 
/ ’ 
I 
Figure 6.20 Siemens DYAD Telephone Button Depression Sequence 
6-21  

SATURN IIE EPABX 
Installation Test Procedures A30808-X5130-BlZO-l-8928 
Issue 1, May 1986 
Table 6.06 Siemcns Digital Telephone - JR-DYAD Button Test 
NOTES: 1) If the system option flag TSTDIAG has been enabled in the data base or the Siemens Digital Telephone under 
test is classmarked with TSTAPP feature, the maintenance test phone is ‘not required to enable or disable the 
Apparatus Diagnostic routines; therefore, perform only steps‘5 through 9. 
2) If the system option flag TSTDIAG has been...