Sharp Ux Cc500 5 In 1 Communication Center With Expandable C Operation Manual

99
8. Printing 
Lists
8.  Printing Lists
You can print lists showing settings and information entered in the fax 
machine. The lists are described below. To print a list, follow these steps.
1Press   once and   twice.
2Press  once.
3Press   or   until the desired list appears in the display.
4Press  once.
5Press   to print the list.
FUNCTION
START/MEMORY
Display:
LISTING MODE
TEL # LIST
PRESS START KEY

(
3
3õ
)
6
6
2
¦
¦

(
.
,
¦


¦
¦


9
0
+
(
@ó
¦

(
@
¦úøó
¦ù÷÷ù
¦
¦


û

¦

 

Printing Lists
100
Message List
This list shows information about the messages currently recorded in the 
answering machine, including the date and time each messages was 
recorded, the length, and the type.
Caller-ID List
This list shows information about your 30 most recent calls. (This list is only 
available if you are using the Caller ID function.)
Telephone Number List
This list shows the fax and phone numbers that have been stored in the 
Common book for automatic dialing.
Setup List
This list...

Printing Lists
101
8. Printing 
ListsTransaction Report
This report is printed out automatically after an operation is completed to 
allow you to check the result. Your fax machine is set at the factory to print out 
the report only when an error occurs. 
♦The Transaction report cannot be printed on demand.
Headings in Transaction Report
SENDER/
RECEIVERThe name or fax number of the other machine involved in the 
transaction. If that machine does not have an ID function, the 
communication mode will...

Printing Lists
102
Transaction Report print condition
You can change the condition under which a Transaction Report is printed out. 
Follow the steps below.
1Press   once and   once.
2Press   once and   once.
3Press  once.
4Press a number from   to   to select the condition for printing.
5Press   to return to the date and time display.ALWAYS PRINT A report will be printed after each 
transmission, reception, or error.
ERROR/MEMORY A report will be printed after an error or a 
memory operation.
SEND ONLY...

103
9. Maintenance
9.  Maintenance
Print head
Clean the print head frequently to ensure optimum printing performance.
Note: Remove the paper from the paper tray before cleaning the print head.
1Unplug the power cord, and open the 
operation panel (press 

).
2Take the imaging film out of the print 
compartment and place it on a sheet of 
paper.
3Wipe the print head with isopropyl 
alcohol or denatured alcohol.
Caution!
•Do not use benzene or thinner. Avoid 
touching the print head with hard 
objects....

Maintenance
104
4Place the imaging film back in the print 
compartment.
5Rotate the front gear until the film is taut, and then close the operation 
panel (press down on both sides to make sure it clicks into place).
Scanning glass and rollers
Clean the scanning glass and rollers frequently to ensure the quality of 
transmitted images and copies. 
Note: Remove the paper from the paper tray before cleaning the scanning 
glass and rollers.
1Open the operation panel (press 
).
1
2

(
3
3

Maintenance
105
9. Maintenance
2Flip up the green levers on each side of 
the white roller.
3Wipe the scanning glass (under the 
white roller) and rollers with a cotton 
swab.
•Make sure that all dirt and stains (such 
as correcting fluid) are removed. Dirt 
and stains will cause vertical lines on 
transmitted images and copies.
If the scanning glass is difficult to clean
If you find it difficult to remove dir t from the scanning glass, you can try moistening 
the swab with isopropyl alcohol or denatured...

Maintenance
106
Replacing the Cordless Handset Battery
Like any other battery, the rechargeable battery will eventually wear out. The 
battery can normally be used for about two years, although this will vary 
depending on the conditions of use.
If LOW BATTERY continues to appear in the cordless handset display after 
the battery has been charged for 10 hours, replace it with the following 
battery:
Replacement battery: Use only a Sharp UX-BA01 battery 
(3.6 V Ni-MH battery, capacity: 850 mAh)
Caution:...

Maintenance
107
9. Maintenance
4Place the battery cover on the cordless 
handset, making sure it snaps firmly 
into place.
5Place the cordless handset in the 
charger with the dial pad facing 
forward.
•Let the new battery charge for at least 
10 hours.
Battery disposal
The battery pack contains a Nickel Metal Hydride battery. The battery must be 
disposed of properly. Contact local agencies for information on recycling and 
disposal plans in your area.
Wiping the charger contacts
To ensure that the...

108
10.  Troubleshooting
Problems and Solutions
If you have any problems with your fax, first refer to the following 
troubleshooting guide. If you cannot solve the problem, call Sharps Customer 
Assistance Center at 1-877-794-8675.
Line error
Problem Solution
LINE ERROR appears in 
the display.Try the transaction again. If the error persists, check 
the following:
Check the connection. The cord from the TEL. 
LINE jack to the wall jack should be no longer than 
six feet.
Make sure there are no modem...