Panasonic Marine Case Dmw-mcft5 Operating Instructions
Have a look at the manual Panasonic Marine Case Dmw-mcft5 Operating Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 10737 Panasonic manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

(ENG) VQT4V8311 6Inspect the O-ring one last time. Check the following one more time:•There is no dirt sticking to the O-ring.•The O-ring has not come out.•The O-ring is not twisted.•There are no scratches or squashed parts on the O-ring.Thoroughly wipe any grease off your hands with a dry cloth. Afterwards wash thoroughly with fresh water. 7Close the buckle. • Check that no foreign materials are sticking to the outer surface of the O- ring or the buckle on the front case and then close the Case. Notes•To keep the Case completely airtight, do not scratch the surface of the O-ring that comes into contact with the sides of the Case. •Never use an O-ring that has been scratched or damaged by dirt etc. This will cause water leakage. •Each time you use the Case, remove the O-ring and check that there is no dirt, sand, hair or other foreign materials in the O-ring groove and then apply a thin coat of grease (supplied). If you apply too much grease, dirt and the dust may stick to the O-ring causing water leakage. •Be sure to bring a spare O-ring in case the O-ring that you are using becomes damaged or scratched. DMW-MCFT5_PP&E-VQT4V83.book 11 ページ 2013年1月16日 水曜日 午前11時35分

VQT4V83 (ENG)12 Checking the Case is Waterproof After setting the O-ring, check that no water leaks into the Case by submerging it in a water tank, bath tub etc. for about 3 minutes before attaching a digital camera. •Do not use the Case in water over 40 °C/104 °F. The heat may damage the Case or cause water leakage. •Carry out the same test after attaching the digital camera to the Case. (P15) Notes•If bubbles rise from the Case when it is submerged in water or there is water inside the Case when you take it out of the water, there is water leakage. In these cases, consult your dealer. •If water leaks into the Case while you are using it and the digital camera is submerged in water, remove the battery immediately. Hydrogen gas can cause burning or explosion if there is a fire nearby. •If you dive quickly while holding the Case or throw the Case from a ship into the sea, some water leakage may occur because of high pressure. This is not a malfunction of the Case. Always dive slowly into the water. •The Case is designed to be used at a depth of up to 45 m/148 feet. If you dive deeper than 45 m/148 feet, part of the Case may be damaged beyond repair. •When closing the Case, be careful that no foreign materials get caught between the O-ring and the O-ring groove. Even one strand of hair or one grain of sand can cause water leakage. DMW-MCFT5_PP&E-VQT4V83.book 12 ページ 2013年1月16日 水曜日 午前11時35分

(ENG) VQT4V8313 Attaching the Digital Camera Read the notes on page 15 before attaching the digital camera. Turn off the digital camera and remove the strap from it. 1Push 2 up with your finger while sliding 1 to open the buckle. 2Attach the digital camera to the Case. Be careful of the direction and insert the digital camera into the Case as shown in the illustration. •Check that there is no remaining water inside the digital camera and the Case. •Be careful not to catch the shading hood 1. 1Front Case DMW-MCFT5_PP&E-VQT4V83.book 13 ページ 2013年1月16日 水曜日 午前11時35分

VQT4V83 (ENG)14 3Insert the silica gel (supplied). • If the air temperature is high and the water temperature is low, condensation may appear inside the Case. To prevent condensation, insert silica gel (supplied) inside the Case in advance. To prevent the Case from becoming fogged up, insert the silica gel about 1 to 2 hours before using the Case. •Always use new silica gel. •When inserting the silica gel, bend it as shown in the illustration below and then insert it as far as possible. If you close the Case with the silica gel not fully inserted, the silica gel will get caught in the O- ring causing water leakage. 4Close the buckle. Silica gelDigital Camera Silica gel DMW-MCFT5_PP&E-VQT4V83.book 14 ページ 2013年1月16日 水曜日 午前11時35分

(ENG) VQT4V8315 •Check that the buckle is closed firmly. Do not insert the strap etc. in the buckle. 5After you have attached the digital camera, check one more time that no water leaks into the Case. (P12) Notes•Be careful not to get the shading hood dirty with fingerprints etc.•Check one more time that the O-ring is fitted evenly into the O-ring groove.•Avoid opening or closing the Case where there is a lot of sand or dust and in humid or wet places. •If there is a sudden change of humidity caused by moist air entering the Case, condensation may appear inside the Case. •To prevent condensation, set the digital camera in as dry a place as possible. Also, check that the silica gel (supplied) is sufficiently dry before inserting. •If sunscreen or suntan oil sticks to the Case, wash it off immediately with lukewarm water to prevent reduced waterproofness or discoloration. •Submerge in fresh water for approximately 10 minutes after using the digital camera at the beach or in water. Read the operating instructions for details. When using a digital camera with GPS/Wi-Fi ®/NFC function ±: Available —: Not available ¢1 If a digital camera is attached to the marine case, failure of positioning or other major errors may occur due to interference in the reception of radio waves from the GPS satellite. ¢2 When connecting the digital camera to a smartphone by using the NFC function, do so before attaching it to the marine case. “Wi-Fi” is a registerd mark of the “Wi-Fi Alliance”. When a digital camera with compass, altimeter (depth meter), and barometer is attached to the marine case, measurements may not be possible, or may contain major errors. GPSWi-FiNFC When the marine case is attached ±¢1±¢2— Underwater use —— — DMW-MCFT5_PP&E-VQT4V83.book 15 ページ 2013年1月16日 水曜日 午前11時35分

VQT4V83 (ENG)16 Taking Pictures ∫Be sure to check the following before entering the waterCheck the following before diving.•Is there sufficient remaining battery power?•Is there sufficient memory in the card?•Is the O-ring fitted evenly into the O-ring groove?•Have you checked that no water leaks into the Case?•Is the buckle closed firmly? ∫Taking pictures 1Turn the camera on. 2Set to the [Advanced Underwater Mode]. 3Aim the AF area on the LCD monitor at the subject you want to focus on. 4Fix the focus and take the picture. Notes•If there are any particles floating in front of the camera, it may focus on them instead of the subject. •If there are drops of water or dirt sticking to the front glass, you may not be able to focus properly. Be sure to wipe the front glass before taking pictures. •Sound cannot be recorded correctly when recording motion pictures. For details of [Advanced Underwater Mode] setting or fixing the focus, refer to the operating instructions of the digital camera. DMW-MCFT5_PP&E-VQT4V83.book 16 ページ 2013年1月16日 水曜日 午前11時35分

(ENG) VQT4V8317 Tips for Taking Pictures in the Water It is recommended to use the Recording Mode (Advanced Underwater) appropriate for underwater when recording underwater. It may not be possible to record images with intended brightness or color depending on the recording conditions (depth/weather/subject), so try using following functions together. It is recommended to use burst function to record subject that is moving fast, etc.Note •For details of white balance fine adjustment (Advanced Underwater Mode) or other functions, refer to the operating instructions of the digital camera. Color is reddish, bluish White balance fine adjustment (Advanced Underwater Mode) •This can adjust the red or blue tone. Too bright/ too darkExposure compensation (For models with an Exposure Compensation Function)•This can adjust the brightness. Auto bracket function (For models with an Auto Bracket Function) •This can record multiple images with different exposure at once. DMW-MCFT5_PP&E-VQT4V83.book 17 ページ 2013年1月16日 水曜日 午前11時35分

VQT4V83 (ENG)18 After Use After you have finished taking pictures, follow the steps below. 1Submerge the Case in fresh water for about 30 minutes or more without removing the digital camera to remove any salt crystals etc. • Press all the operation buttons etc. on the Case to wash away any seawater. If the salt crystals are not removed from the buttons etc., they will harden and the buttons will become inoperable. •Do not wash the Case with fast-running or pressurized water etc. as it may cause water leakage. 2Wipe the water with a dry cloth that has no salt crystals sticking to it and then dry the Case completely. • Do not dry the Case by exposing it to direct sunlight. This may discolor or damage the Case or may hasten deterioration of the O-ring. DMW-MCFT5_PP&E-VQT4V83.book 18 ページ 2013年1月16日 水曜日 午前11時35分

(ENG) VQT4V8319 3Open the rear of the case to remove the digital camera. After thoroughly wiping your hands, apply your finger as shown in the illustration and take out the digital camera. 4Remove the O-ring from the Case and check that there is no dirt etc. in the O-ring groove. 5Check that there are no scratches etc. on the O-ring while you are applying the grease. Notes Be careful of the following points when taking out the digital camera. •Remove the camera with clean hands. (Wash your hands with fresh water and then thoroughly dry them.) •Thoroughly dry any moisture on your body or hair. (Be particularly careful about any water coming from the sleeves of your thermal suit.) DMW-MCFT5_PP&E-VQT4V83.book 19 ページ 2013年1月16日 水曜日 午前11時35分

VQT4V83 (ENG)20 Cleaning and Storing 1Wash the outside of the Case with water. • Wash the outside of the Case until it is clean. (P18)•Confirm that the O-ring is set securely, be sure to close the Case, and then wash only the outside with water. •Wipe off any dirt inside the Case with a wet, soft cloth. 2Store the Case after drying it thoroughly at room temperature. Notes•Do not wash the Case with high-pressure water as it may cause water leakage. Remove the digital camera before washing the Case with water. •Do not leave the digital camera inside the Case when storing it.•Detach the O-ring from the marine case and store so it will not dry. For details, please read page 21. When storing for a long period of time, insert in the supplied exclusive polyester bag after first removing the O-ring. Handling and Care •Do not place the Case where it may fall.–If the Case falls on your head or foot, it will injure you and cause the Case to malfunction. •Never alter the Case.–If water leaks into the digital camera because the Case was altered, the digital camera may be damaged beyond repair. –If you continue to use the digital camera after water has leaked into it, this may cause a fire. •Do not use the Case while scuba diving without proper training.–You should only operate the Case while scuba diving if you have been properly trained and certified for this sport. •Never place the Case, grease, silica gel or O-ring within the reach of infants.–If any part of an infant’s body is caught in the Case, it may cause an injury.–Infants may accidentally swallow the grease, silica gel or O-ring.–Consult a doctor immediately if you think an infant may have swallowed the grease, silica gel or O-ring. •Do not hang the strap around your neck underwater.–It may become wound around your neck causing suffocation or other serious injuries. DMW-MCFT5_PP&E-VQT4V83.book 20 ページ 2013年1月16日 水曜日 午前11時35分