Panasonic Cpc+AII/B Digital Business System Release Notes Manual

Chapter 6. Name and Message Assicjnments (FFG)Section 400-Programming
Call Waiting/OHVA Text Reply
Software Version:CPC-All (all versions); CPC-6 Version 2.0 or higherAddress: FF6 
7# (l-5)# CONF (NNNNNNNNNNNNNNN)#
DescriptionWhen a busy party receives an indication of an incoming intercom call, the
busy party can respond by sending a text message back to the caller.
The text message can be sent after a Call Waiting tone, an 
OfRook Voice
Announce, or a Call Waiting tone followed by 
Offhook Voice...

Section 400-Programming
Chapter 6. Name and Message Assignments (FF6)
DlDlDNlS Text Name Assignment
Software Version:
CPC-B Version 5.0 or higherAddress: DID: FF6 
8# (l-200)# (1 or 2)# (0000-9999)# (NNNNNN)#
DNIS: 
FF6 9# (l-200)# (1 or 2)# (000019999)# (NNNNNN)#
DescriptionAssign DID/DNIS names of up to 6 characters long for specific DID/DNTS
numbers.
DID/DNIS text names can only be assigned via FF6 programming. The DID/
DNIS number must already be assigned to an extension, before you can
assign a name...

7. Toll Restrictions (FF7)Use the FF7 program addresses in this chapter to perform Toll Restriction
Service (TRS) programming.
This chapter covers the following addresses:
FF7 Address
aliFF7addresses
Topic
An Overview of Toll RestrictionsPage7-2
FF7 I# l# (0 or l)#
t
1 International Calling For TRS TvDes 3-6
FF7 1#2#(0 or l)#DTMF Signaling During Incoming Calls For TRS
Types O-6
7-5
7-6
FF7 1#3#(1-15)#1 Maximum Dialed Digits For TRS Types 3-61 7-7
FF7 1# 4# thru lOl# (0 or l>#3-Digit Toll Restriction For...

An Overview of Toll Restrictions
The DBS Toll Restriction Service (TRS) allows you to set restrictions on outgoing calls.
For example, TRS can prohibit long-distance calls and prevent after-hours calls. TRS
can also minimize non-business calls and reduce phone bills by permitting only 
long-
distance calls over designated trunks.
The DBS system supports up to eight different TRS types (see table below). A TRS
type can be assigned to each trunk to activate toll restriction.
Table 7-L. ,Toll restriction...

Sectton 400~ProgrammingUtapter 7. Toll Restriction (FF7)
TRS Type Characteristics
5lProgrammable TRS type; all area codes and office codes are allowed by
default.
6l Identical to TRS type 5.
7l Cannot restrict any dialing.
NotesNew NANP Vialing Plan.Beginning with CPC-AlID3 Version 6.0, changes
to the North American Numbering Plan (NANP) are supported. These
changes affect TRS parameters, which is explained in the affected program
addresses in this chapter.
Table 7-2. NANP changes
(
1
1
1
C
I
I
I
9
C
L...

Change
Long-Distance Calls
International Calls
Old Numbering PlanNew NANP Plan
(Versions prior to 6.0)(Version 6.0 or higher)
1) Check Special Area/Office Codes. 1) Check Special Area/Office Codes.
2) Check Area Code Table.2) Check Area Code Table.
3) Check Add/Delete Digits.
3) Check new Off’ce Code Restric-
tion Table (up to 10 entries).
4) Check Add/Delete Digits.
Allowed or restricted system-wideSelectable restriction on extensions
by TRS type assigned to trunk.if using trunks with TRS types 3-6....

Section 400-ProgrammingChapter 7. Toll Restriction (FF7)
International Calling For TRS Types 3-6
Software Version: All VersionsAddress: 
FR I# 1# (0 or l)#
DescriptionUse this address to allow or deny international calls on trunks that are
assigned TRS types 3-6.
If the DBS is set to use the new NANP dialing plan (available with CPC-A
Version 4.0 or higher, and 
CPC-AII/B Version 6.0 or higher), this address
determines whether the DBS will check the Country Code Table for any
restrictions on the dialed...

Chapter 7. Toll Restriction (FF7)Section 400~Programming
DTMF Signaling During Incoming Calls For TRS
Types O-6
Software Version: All VersionsAddress: 
FFi’ l# 2# (0 or l)#
DescriptionThis address determines if DTMF signaling can be sent to the CO after an
extension picks up an incoming trunk call.
If an extension receives a call on a trunk assigned to TRS type O-6, the
extension user may try to bypass ‘lRS restrictions by dialing an outgoing call
while still off-hook. (After the outside caller hangs up,...

Section 400-Programming
Chapter 7. Toll Restriction (FF7)
Maximum Dialed Digits For TRS Types 3-6
Software Version: Ail VersionsAddress: FF7 
I# 3# (l-15)#
DescriptionThe maximum number of dialed digits on trunks assigned TRS types 3-6 can
be set from 15 to 29. By default, the maximum number is unlimited.
ProgrammingFF7 
l# 3# (l-15)#
f
Maximum Number of Dialed Digits Allowed
Note: The default setting is ** (unlimited). To change
the setting to a limited number of digits, enter 
l- 15
(see table below...

Chapter 7. Toll Restriction (FF7)Section 400-Programming
3-Digit Toll Restriction For TRS Types 2-6
Software Version: All VersionsAddress: 
FR 1# (4-11)# (0 or l)#
DescriptionUse this address to to allow or deny the dialing of 211-911 numbers on trunks
that are assigned TRS types 2-6. By default, 
all of these numbers are allowed.
If the DBS is set to use the nm NANP dialing plan (available only with CPC-
All/B Version 6.0 or higher), “911” is always allowed for T.RS types 2-6,
regardless of the setting...